lkml.org 
[lkml]   [2016]   [Sep]   [27]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH v7 0/8] power: add power sequence library
On Wed, Sep 28, 2016 at 01:30:17AM +0200, Maciej S. Szmigiero wrote:
> On 20.09.2016 05:36, Peter Chen wrote:
> > Hi all,
> >
> > This is a follow-up for my last power sequence framework patch set [1].
> > According to Rob Herring and Ulf Hansson's comments[2]. The kinds of
> > power sequence instances will be added at postcore_initcall, the match
> > criteria is compatible string first, if the compatible string is not
> > matched between dts and library, it will try to use generic power sequence.
> >
> > The host driver just needs to call of_pwrseq_on/of_pwrseq_off
> > if only one power sequence instance is needed, for more power sequences
> > are used, using of_pwrseq_on_list/of_pwrseq_off_list instead (eg, USB hub driver).
> >
> > In future, if there are special power sequence requirements, the special
> > power sequence library can be created.
> >
> > This patch set is tested on i.mx6 sabresx evk using a dts change, I use
> > two hot-plug devices to simulate this use case, the related binding
> > change is updated at patch [1/6], The udoo board changes were tested
> > using my last power sequence patch set.[3]
> >
> > Except for hard-wired MMC and USB devices, I find the USB ULPI PHY also
> > need to power on itself before it can be found by ULPI bus.
> >
> > [1] http://www.spinics.net/lists/linux-usb/msg142755.html
> > [2] http://www.spinics.net/lists/linux-usb/msg143106.html
> > [3] http://www.spinics.net/lists/linux-usb/msg142815.html
>
> Just tested this patch set on UDOO board again to make sure that it still
> works after all changes done since it was last tested there and can confirm
> that it does work correctly.
>

Thanks, Maciej.

--

Best Regards,
Peter Chen

\
 
 \ /
  Last update: 2016-09-28 01:55    [W:0.136 / U:0.644 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site