lkml.org 
[lkml]   [2016]   [Aug]   [18]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH 1/3] dt/bindings: arm-pl330: add description of arm,pl330-periph-burst
On Wed, Aug 17, 2016 at 04:11:03PM +0800, Shawn Lin wrote:
> Hi, Vinod and Lars-Peter
>
> Ping.. Any better idea to share :)
>
> On 2016/8/9 17:12, Shawn Lin wrote:
> >Hi Lars-Peter,
> >
> >在 2016/8/9 16:39, Lars-Peter Clausen 写道:
> >>On 08/05/2016 09:25 AM, Shawn Lin wrote:
> >>>Hi Vinod,
> >>>
> >>>在 2016/8/5 11:34, Vinod Koul 写道:
> >>>>On Fri, Aug 05, 2016 at 10:53:20AM +0800, Shawn Lin wrote:
> >>>>>This patch adds the "arm,pl330-periph-burst" for arm-pl330 to
> >>>>>support busrt mode.
> >>>>
> >>>>why should this be DT property. Only reason I can think of if some hw
> >>>>versions support this and some won't.
> >>>
> >>>yes, if we want to support burst mode, both of the master(pl330) and
> >>>client(several peripherals) should implement it, otherwise it will
> >>>be broken when enabling.
> >>
> >>As you said, it is up to the consumer peripheral whether it supports
> >>BURST,
> >>SINGLE or both. So this is a per client property, but you specify this
> >>as a
> >>a global property on the producer side.
> >
> >Thanks for comment.
> >
> >yup, but what is the proper way to add it ? :)
> >
> >
> >a) If pl330 support BURST as well as all the peripherals, we could
> >enable it.
> >
> >b) If pl300 support BURST, but all the peripherals don't support it,
> >we could not enable it.
> >
> >c) If pl300 support BURST, but not all the peripherals support it,
> >we also could not enable it.
> >
> >the burst feature of peripheral IP may be vendor-specific, but the
> >common driver for this peripheral are used for many many vendors which
> >means we could not check all of this info. It's very likely to break
> >them... I couldn't figure out how many upstreamed peripheral drivers
> >who are using pl300 either.
> >
> >So this check should be done by all this vendors but we could make
> >sure we don't break them before they check a), b), c), right?

Since support for BURST needs to be from peripheral too, we should have
that as a property for peripheral not for controller.

The peripheral drivers can communicate the burst to be used to pl330
using src_maxburst/dst_maxburst in dma_slave_config. We can use this
value to indicate the DMA should be single (a value of 0) or burst with
"burst" value.

--
~Vinod

\
 
 \ /
  Last update: 2016-09-17 09:57    [W:0.987 / U:0.016 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site