lkml.org 
[lkml]   [2016]   [Jul]   [4]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH v3 1/2] clk: exynos5433: do not use CLK_IGNORE_UNUSED for SPI clocks
Hi Sylwester,

> > GATE(CLK_SCLK_SPI1, "sclk_spi1", "sclk_spi1_peric", ENABLE_SCLK_PERIC,
> > - 4, CLK_IGNORE_UNUSED | CLK_SET_RATE_PARENT, 0),
> > + 4, CLK_IS_CRITICAL | CLK_SET_RATE_PARENT, 0),
>
> As Tomasz pointed out, this should be addressed in the driver/dts,
> we shouldn't be patching board configurations into a per-SoC driver.
> Other boards may want to keep this clock disabled.

The single clock lines are not configured in the exynos5433 dts,
but in the drivers/clk/samsung/clk-exynos5433.c file and it's the
only place where we can set the flags.

> What is an exact problem here, are you perhaps testing suspend to RAM?
> I tested my sound support patches on top of v4.7-rc1 and everything
> seemed to work well, I didn't notice any issues with the audio codec
> which was the only slave on the SPI 1 bus.

Yes, because the audio codec is on SPI1 and its bus line
(spi_busclk0) is CLK_SCLK_SPI1_PERIC while the CLK_SCLK_SPI1 is
set as CLK_IGNORE_UNUSED.

> Doesn't it help when you specify CLK_SCLK_SPI1 as the second clock
> ("spi_busclk0") of the spi_1 bus controller instead of
> CLK_SCLK_SPI0_PERIC? CLK_SCLK_SPI0_PERIC seem to be parent of
> CLK_SCLK_SPI1 so the enable state would be propagated.

nope! :(

For some reasons, if you set in the DTS as spi_busclk0 the
CLK_SCLK_SPI1 from cmu_peric you get a synchronus abort in the
s3c64xx_spi_config (the first read performed on the device).

Andi

\
 
 \ /
  Last update: 2016-07-04 12:41    [W:0.071 / U:0.584 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site