lkml.org 
[lkml]   [2016]   [Jul]   [28]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH] genirq/msi: Make sure PCI MSIs are activated early
On Thu, Jul 28, 2016 at 05:03:30PM +0200, Thomas Gleixner wrote:
> On Tue, 26 Jul 2016, Thomas Gleixner wrote:
> > On Tue, 26 Jul 2016, Thomas Gleixner wrote:
> > > On Tue, 26 Jul 2016, Thomas Gleixner wrote:
> > > > On Mon, 25 Jul 2016, Bjorn Helgaas wrote:
> > > > > On Mon, Jul 25, 2016 at 09:45:13AM +0200, Thomas Gleixner wrote:
> > > > > I thought the original issue [1] was that PCI_MSI_FLAGS_ENABLE was being
> > > > > written before PCI_MSI_ADDRESS_LO. That doesn't sound like a good
> > > > > idea to me.
> > > >
> > > > Well. That's only a problem if the PCI device does not support masking. But
> > > > yes, we missed that case back then.
> > > >
> > > > > That does seem like a problem. Maybe it would be better to delay
> > > > > setting PCI_MSI_FLAGS_ENABLE until after the MSI address & data bits
> > > > > have been set?
> > > >
> > > > I thought about that, but that gets ugly pretty fast. Here is an alternative
> > > > solution.
> > > >
> > > > I think that's the proper place to do it _AFTER_ the hierarchical allocation
> > > > took place. On x86 Marc's ACTIVATE_EARLY flag would not work because the
> > > > message is not yet ready to be assembled.
> > >
> > > Actually it works, because the MSI domain is the last one which is running the
> > > allocation function. So everything else is initialized already.
> > >
> > > I'll take Marc's patch with some additional commentry as it turned out to be a
> > > workaround for the reported VMware issues with PCI/MSI-X pass through.
> >
> > Now I digged a little bit deeper into all that PCI/MSI maze.
> >
> > When a interrupt is freed, then we write the msi message to 0, but the
> > PCI_MSI_FLAGS_ENABLE flag is still set. That makes me wonder ...
>
> Bjorn, any opinion on that?

I assume you mean we write 0 to PCI_MSI_ADDRESS_LO, PCI_MSI_DATA_32,
and similar registers in the MSI Capability structure.

It doesn't sound safe to me to do that while PCI_MSI_FLAGS_ENABLE is
still set. I don't see anything in the spec that constrains when a
device latches the values from those registers. It seems legal to do
it on PCI_MSI_FLAGS_ENABLE transitions, but it also seems legal to do
it whenever the device needs to signal an interrupt.

If a device does the latter, it seems like clearing PCI_MSI_ADDRESS_LO
while PCI_MSI_FLAGS_ENABLE is set could lead to stray DMA writes if
the device for some reason signals an interrupt later.

Bjorn

\
 
 \ /
  Last update: 2016-07-28 19:21    [W:0.079 / U:0.072 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site