lkml.org 
[lkml]   [2016]   [Jul]   [26]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v2] README: Delete obsolete i386 info + update arch/i386/ paths
Date
Support for i386 was removed in v3.8, delete the paragraph that says
processor types above 386 won't work on that architecture. It's obsolete
information and potentially confusing. Also change a couple of
"arch/i386/" paths to one that exists now, using "arch/x86/" instead.

Signed-off-by: Øyvind A. Holm <sunny@sunbase.org>
---
README | 8 ++------
1 file changed, 2 insertions(+), 6 deletions(-)

diff --git a/README b/README
index e8c8a6d..09f34f7 100644
--- a/README
+++ b/README
@@ -229,10 +229,6 @@ CONFIGURING the kernel:
under some circumstances lead to problems: probing for a
nonexistent controller card may confuse your other controllers

- - Compiling the kernel with "Processor type" set higher than 386
- will result in a kernel that does NOT work on a 386. The
- kernel will detect this on bootup, and give up.
-
- A kernel with math-emulation compiled in will still use the
coprocessor if one is present: the math emulation will just
never get used in that case. The kernel will be slightly larger,
@@ -289,7 +285,7 @@ COMPILING the kernel:
LOCALVERSION can be set in the "General Setup" menu.

- In order to boot your new kernel, you'll need to copy the kernel
- image (e.g. .../linux/arch/i386/boot/bzImage after compilation)
+ image (e.g. .../linux/arch/x86/boot/bzImage after compilation)
to the place where your regular bootable kernel is found.

- Booting a kernel directly from a floppy without the assistance of a
@@ -391,7 +387,7 @@ IF SOMETHING GOES WRONG:

- Alternatively, you can use gdb on a running kernel. (read-only; i.e. you
cannot change values or set break points.) To do this, first compile the
- kernel with -g; edit arch/i386/Makefile appropriately, then do a "make
+ kernel with -g; edit arch/x86/Makefile appropriately, then do a "make
clean". You'll also need to enable CONFIG_PROC_FS (via "make config").

After you've rebooted with the new kernel, do "gdb vmlinux /proc/kcore".
--
2.9.2.466.g8c6d1f9
\
 
 \ /
  Last update: 2016-07-26 16:01    [W:0.035 / U:0.084 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site