lkml.org 
[lkml]   [2016]   [Jun]   [8]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[RESEND PATCH 2/3] mtd: nand: Support maximizing ECC when using software BCH
Date
Add support for ECC maximization when software BCH with
nand_ooblayout_lp_ops layout is used.
Other cases should be handled by the NAND controller driver.

Signed-off-by: Boris Brezillon <boris.brezillon@free-electrons.com>
---
drivers/mtd/nand/nand_base.c | 20 ++++++++++++++++++++
1 file changed, 20 insertions(+)

diff --git a/drivers/mtd/nand/nand_base.c b/drivers/mtd/nand/nand_base.c
index d374129..ca4f53d 100644
--- a/drivers/mtd/nand/nand_base.c
+++ b/drivers/mtd/nand/nand_base.c
@@ -4224,6 +4224,7 @@ static int nand_set_ecc_soft_ops(struct mtd_info *mtd)
ecc->write_page_raw = nand_write_page_raw;
ecc->read_oob = nand_read_oob_std;
ecc->write_oob = nand_write_oob_std;
+
/*
* Board driver should supply ecc.size and ecc.strength
* values to select how many bits are correctable.
@@ -4246,6 +4247,25 @@ static int nand_set_ecc_soft_ops(struct mtd_info *mtd)
}

mtd_set_ooblayout(mtd, &nand_ooblayout_lp_ops);
+
+ }
+
+ /*
+ * We can only maximize ECC config when the default layout is
+ * used, otherwise we don't know how many bytes can really be
+ * used.
+ */
+ if (mtd->ooblayout == &nand_ooblayout_lp_ops &&
+ ecc->options & NAND_ECC_MAXIMIZE) {
+ int steps, bytes;
+
+ /* Always prefer 1k blocks over 512bytes ones */
+ ecc->size = 1024;
+ steps = mtd->writesize / ecc->size;
+
+ /* Reserve 2 bytes for the BBM */
+ bytes = (mtd->oobsize - 2) / steps;
+ ecc->strength = bytes * 8 / fls(8 * ecc->size);
}

/* See nand_bch_init() for details. */
--
2.7.4
\
 
 \ /
  Last update: 2016-06-08 17:21    [W:2.113 / U:0.004 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site