lkml.org 
[lkml]   [2016]   [Jun]   [6]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH] ARM64: boot: dts: Add regulators for Tegra210 Smaug
From
Date
On 6/6/2016 2:39 AM, Laxman Dewangan wrote:
>
> On Saturday 04 June 2016 01:52 AM, Rhyland Klein wrote:
>> +
>> + max77620_default: pinmux@0 {
>> + pin_gpio {
>> + pins = "gpio0", "gpio1", "gpio2", "gpio5",
>> + "gpio6", "gpio7";
> gpio5 and gpio6 are already there in below nodes and hence it is not
> needed here.

Yep thanks.

>
>> + function = "gpio";
>> + };
>> +
>> + /*
>> + * GPIO3 is used to en_pp3300, and it is part of power
>> + * sequence, So it must be sequenced up (automatically
>> + * set by OTP) and down properly.
>> + */
>> + pin_gpio3 {
>> + pins = "gpio3";
>> + function = "fps-out";
>> + drive-open-drain = <1>;
>> + maxim,active-fps-source = <MAX77620_FPS_SRC_0>;
>> + maxim,active-fps-power-up-slot = <4>;
>> + maxim,active-fps-power-down-slot = <2>;
>> + };
>> +
>> + pin_gpio5_6_7 {
> node name should be gpio5_6 as there is no gpio7 inside this node.

Thanks.
>
>
>> +
>> + regulators {
>> + in-ldo0-1-supply = <&pp1350>;
>> + in-ldo2-supply = <&pp3300>;
>> + in-ldo3-5-supply = <&pp3300>;
>> + in-ldo7-8-supply = <&pp1350>;
>> +
>> + ppvar_soc: sd0 {
>> + regulator-name = "PPVAR_SOC";
>> + regulator-min-microvolt = <825000>;
>> + regulator-max-microvolt = <1125000>;
>> + regulator-enable-ramp-delay = <146>;
>> + regulator-disable-ramp-delay = <4080>;
>> + regulator-ramp-delay = <27500>;
>> + regulator-ramp-delay-scale = <300>;
>
> There is no disable-ramp-delay in mainline.
> Please use the correct value for property as:
> regulator-ramp-delay = <9000>;
> maxim,ramp-rate-setting = <27500>;
>
>
> instead of regulator-ramp-delay and regulator-ramp-delay-scale.
> The property differs from downstream.
>
> regulator-ramp-delay is what you see in platform and
> maxim,ramp-rate-setting is what you want in register.

Where does "<9000>" come from in the above comment? It looks like
maxim,ramp-rate-setting sets the slew rate, and regulator-ramp-delay
will as well, but will be ignored if maxim,ramp-delay-setting is set. So
does it ever make sense to have both defined for a regulator? And if
not, should max77620 regulators just use the maxim property and not the
regulator core property?

-rhyland

--
nvpublic

\
 
 \ /
  Last update: 2016-06-07 00:21    [W:0.053 / U:0.084 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site