Messages in this thread | | | From | Ivan Khoronzhuk <> | Subject | [PATCH 0/4] net: ethernet: ti: cpsw: add multi-queue support | Date | Thu, 30 Jun 2016 22:04:34 +0300 |
| |
This series is intended to allow cpsw driver to use its ability of h/w shaper to send/receive data with up to 8 tx and rx queues. This series doesn't contain interface to configure h/w shaper itself, it contains only multi queue support part and ability to configure number of tx/rx queues with ethtool. Default shaper mode - priority mode. The h/w shaper configuration will be added with separate patch series. This series doesn't affect on net throughput.
Tested on: am572x-idk, 1Gbps link am335-boneblack, 100Mbps link.
Based on: git://git.kernel.org/pub/scm/linux/kernel/git/davem/net-next.git
A simple example for splitting traffic on queues:
#check how many queues are supported and active: $ ethtool -l eth0
#increase number of active rx and tx queues, #by default 1 rx and 1 tx queue #can be set any combination of 0 < rx <= 8 and 0 < tx <= 8 $ ethtool -L eth0 rx 8 tx 8
#set multi-queue-aware queuing discipline $ tc qdisc add dev eth0 root handle 1: multiq
#send packets with ip 172.22.39.12 to queue #5 which can be #prioritized or throughput limited by h/w shaper. $ tc filter add dev eth0 parent 1: protocol ip prio 1 u32 \ match ip dst 172.22.39.12 \ action skbedit queue_mapping 5
#get statistic for active channels: ethtool -S eth0
Ivan Khoronzhuk (4): net: ethernet: ti: davinci_cpdma: split descs num between all channels net: ethernet: ti: cpsw: add multi queue support net: ethernet: ti: davinci_cpdma: move cpdma channel struct macroses to internals net: ethernet: ti: cpsw: add ethtool channels support
drivers/net/ethernet/ti/cpsw.c | 533 +++++++++++++++++++++++++------- drivers/net/ethernet/ti/davinci_cpdma.c | 79 ++++- drivers/net/ethernet/ti/davinci_cpdma.h | 13 +- drivers/net/ethernet/ti/davinci_emac.c | 8 +- 4 files changed, 505 insertions(+), 128 deletions(-)
-- 1.9.1
| |