lkml.org 
[lkml]   [2016]   [Jun]   [29]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Date
SubjectRe: [PATCH v2 2/2] KVM: x86: fix underflow in TSC deadline calculation
2016-06-30 1:16 GMT+08:00 yunhong jiang <yunhong.jiang@linux.intel.com>:
> On Wed, 29 Jun 2016 19:23:57 +0800
> Wanpeng Li <kernellwp@gmail.com> wrote:
>
>> From: Wanpeng Li <wanpeng.li@hotmail.com>
>>
>> INFO: rcu_sched detected stalls on CPUs/tasks:
>> 1-...: (11800 GPs behind) idle=45d/140000000000000/0 softirq=0/0
>> fqs=21663 (detected by 0, t=65016 jiffies, g=11500, c=11499, q=719)
>> Task dump for CPU 1:
>> qemu-system-x86 R running task 0 3529 3525 0x00080808
>> ffff8802021791a0 ffff880212895040 0000000000000001 00007f1c2c00db40
>> ffff8801dd20fcd3 ffffc90002b98000 ffff8801dd20fc88 ffff8801dd20fcf8
>> 0000000000000286 ffff8801dd2ac538 ffff8801dd20fcc0 ffffffffc06949c9
>> Call Trace:
>> ? kvm_write_guest_cached+0xb9/0x160 [kvm]
>> ? __delay+0xf/0x20
>> ? wait_lapic_expire+0x14a/0x200 [kvm]
>> ? kvm_arch_vcpu_ioctl_run+0xcbe/0x1b00 [kvm]
>> ? kvm_arch_vcpu_ioctl_run+0xe34/0x1b00 [kvm]
>> ? kvm_vcpu_ioctl+0x2d3/0x7c0 [kvm]
>> ? __fget+0x5/0x210
>> ? do_vfs_ioctl+0x96/0x6a0
>> ? __fget_light+0x2a/0x90
>> ? SyS_ioctl+0x79/0x90
>> ? do_syscall_64+0x7c/0x1e0
>> ? entry_SYSCALL64_slow_path+0x25/0x25
>>
>> This can be reproduced readily by running a full dynticks guest(since
>> hrtimer in guest is heavily used) w/ lapic_timer_advance disabled.
>>
>> If fail to program hardware preemption timer, we will fallback to
>> hrtimer based method, however, a previous programmed preemption timer
>> miss to cancel in this scenario which results in one hardware
>> preemption timer and one hrtimer emulated tsc deadline timer run
>> simultaneously. So sometimes the target guest deadline tsc is earlier
>> than guest tsc, which leads to the computation in vmx_set_hv_timer
>> can underflow and cause delta_tsc to be set a huge value, then host
>> soft lockup as above.
>>
>> This patch fix it by cancelling the previous programmed preemption
>> timer if there is once we failed to program the new preemption timer
>> and fallback to hrtimer based method.
>>
>> Cc: Paolo Bonzini <pbonzini@redhat.com>
>> Cc: Radim Krčmář <rkrcmar@redhat.com>
>> Cc: Yunhong Jiang <yunhong.jiang@intel.com>
>> Signed-off-by: Wanpeng Li <wanpeng.li@hotmail.com>
>> ---
>> v1 -> v2:
>> * abstract the set_hv_timer and cancel_hv_tscdeadline
>>
>> arch/x86/kvm/lapic.c | 48
>> +++++++++++++++++++++++++----------------------- 1 file changed, 25
>> insertions(+), 23 deletions(-)
>>
>> diff --git a/arch/x86/kvm/lapic.c b/arch/x86/kvm/lapic.c
>> index 9c20ac1..47ce77c 100644
>> --- a/arch/x86/kvm/lapic.c
>> +++ b/arch/x86/kvm/lapic.c
>> @@ -1366,6 +1366,26 @@ void kvm_lapic_expired_hv_timer(struct
>> kvm_vcpu *vcpu) }
>> EXPORT_SYMBOL_GPL(kvm_lapic_expired_hv_timer);
>>
>> +static void start_hv_tscdeadline(struct kvm_lapic *apic)
>> +{
>> + u64 tscdeadline = apic->lapic_timer.tscdeadline;
>> +
>> + if (kvm_x86_ops->set_hv_timer(apic->vcpu, tscdeadline)) {
>> + if (apic->lapic_timer.hv_timer_in_use)
>> + cancel_hv_tscdeadline(apic);
>
> Wanpeng, thanks for the patch.

Thanks for your review, Yunhong. :)

>
>> + start_sw_tscdeadline(apic);
>
> IMHO, it's not good to start_sw_tscdeadline() on the start_hv_tscdeadline()
> function. I think it's expected that the sw_timer is stopped when
> start_hv_tscdeadline() returns successsfully, or sw_timer is not impacted if
> start_hv_tscdeadline() fails. But it's not expected that start_hv_tscdeadline()
> returns successfully while in fact it's the sw_timer started instead :)
>
> Would it be better to simply return failure here, and the caller then
> starts the sw_timer?

Agreed.

>
>> + } else {
>> + apic->lapic_timer.hv_timer_in_use = true;
>> + hrtimer_cancel(&apic->lapic_timer.timer);
>> +
>> + /* In case the sw timer triggered in the window */
>> + if (atomic_read(&apic->lapic_timer.pending))
>> + cancel_hv_tscdeadline(apic);
>> + }
>> + trace_kvm_hv_timer_state(apic->vcpu->vcpu_id,
>> + apic->lapic_timer.hv_timer_in_use);
>> +}
>> +
>> void kvm_lapic_switch_to_hv_timer(struct kvm_vcpu *vcpu)
>> {
>> struct kvm_lapic *apic = vcpu->arch.apic;
>> @@ -1373,20 +1393,8 @@ void kvm_lapic_switch_to_hv_timer(struct
>> kvm_vcpu *vcpu) WARN_ON(apic->lapic_timer.hv_timer_in_use);
>>
>> if (apic_lvtt_tscdeadline(apic) &&
>> - !atomic_read(&apic->lapic_timer.pending)) {
>> - u64 tscdeadline = apic->lapic_timer.tscdeadline;
>> -
>> - if (!kvm_x86_ops->set_hv_timer(vcpu, tscdeadline)) {
>> - apic->lapic_timer.hv_timer_in_use = true;
>> - hrtimer_cancel(&apic->lapic_timer.timer);
>> -
>> - /* In case the sw timer triggered in the
>> window */
>> - if (atomic_read(&apic->lapic_timer.pending))
>> - cancel_hv_tscdeadline(apic);
>> - }
>> - trace_kvm_hv_timer_state(vcpu->vcpu_id,
>> - apic->lapic_timer.hv_timer_in_use);
>> - }
>> + !atomic_read(&apic->lapic_timer.pending))
>
> Not sure if we could put this check into the start_hv_tscdeadline(). It will also
> make the race window all in the same function.

Agreed.

>
>> + start_hv_tscdeadline(apic);
>> }
>> EXPORT_SYMBOL_GPL(kvm_lapic_switch_to_hv_timer);
>>
>> @@ -1453,15 +1461,9 @@ static void start_apic_timer(struct kvm_lapic
>> *apic) ktime_to_ns(ktime_add_ns(now,
>> apic->lapic_timer.period)));
>> } else if (apic_lvtt_tscdeadline(apic)) {
>> - /* lapic timer in tsc deadline mode */
>> - u64 tscdeadline = apic->lapic_timer.tscdeadline;
>> -
>> - if (kvm_x86_ops->set_hv_timer &&
>> - !kvm_x86_ops->set_hv_timer(apic->vcpu,
>> tscdeadline)) {
>> - apic->lapic_timer.hv_timer_in_use = true;
>> - trace_kvm_hv_timer_state(apic->vcpu->vcpu_id,
>> -
>> apic->lapic_timer.hv_timer_in_use);
>> - } else
>> + if (kvm_x86_ops->set_hv_timer)
>> + start_hv_tscdeadline(apic);
>
> As comments above, would it be good to check the return of
> start_hv_tscdeadline() and then start_sw_tscdeadline() if it fails? Just my 2
> cents.

Agreed. I will do these in next version.

Regards,
Wanpeng Li

\
 
 \ /
  Last update: 2016-06-30 01:01    [W:0.055 / U:0.648 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site