lkml.org 
[lkml]   [2016]   [Jun]   [15]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH v3 0/2] Add support for SYSCON reset
From
Date
On 06/01/2016 01:41 PM, Andrew F. Davis wrote:
> Some SoCs contain reset controls for modules that are memory-mapped to
> areas shared with other module configuration settings. This requires
> synchronization across all drivers accessing this memory area. This
> series adds a generic SYSCON reset driver to allow resets toggled
> by bits in memory-mapped registers through SYSCON.
>
> Changes from v2:
> - Rebased on v4.7-rc1
> - Removed the need to give reset specifier nodes an index address
>
> Changes from v1:
> - Reset control information is now described in the reset node, this
> keeps the reset information centralized for easy verification
> - Other small fixups
>
> Andrew F. Davis (2):
> Documentation: dt: reset: Add syscon reset binding
> reset: add a SYSCON based reset driver
>
> .../devicetree/bindings/reset/syscon-reset.txt | 105 ++++++++
> drivers/reset/Kconfig | 10 +
> drivers/reset/Makefile | 1 +
> drivers/reset/reset-syscon.c | 289 +++++++++++++++++++++
> include/dt-bindings/reset/syscon.h | 23 ++
> 5 files changed, 428 insertions(+)
> create mode 100644 Documentation/devicetree/bindings/reset/syscon-reset.txt
> create mode 100644 drivers/reset/reset-syscon.c
> create mode 100644 include/dt-bindings/reset/syscon.h
>

Is there any additional feedback for this driver? I normally try to
refrain from pings, but this may begin to block further upstreaming of
IPs that uses this reset if it can not be taken this cycle.

If there is still an objection to calling this a generic reset solution
we would not strongly object to relabeling this to something implying
more TI exclusivity.

Thanks,
Andrew

\
 
 \ /
  Last update: 2016-06-15 18:21    [W:0.206 / U:4.672 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site