lkml.org 
[lkml]   [2016]   [Jun]   [15]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH v2 02/10] mfd: ac100: Add device tree bindings for X-Powers AC100 codec/RTC combo IC
On Wed, 15 Jun 2016, Chen-Yu Tsai wrote:

> Signed-off-by: Chen-Yu Tsai <wens@csie.org>
> ---
> Documentation/devicetree/bindings/mfd/ac100.txt | 42 +++++++++++++++++++++++++
> 1 file changed, 42 insertions(+)
> create mode 100644 Documentation/devicetree/bindings/mfd/ac100.txt
>
> diff --git a/Documentation/devicetree/bindings/mfd/ac100.txt b/Documentation/devicetree/bindings/mfd/ac100.txt
> new file mode 100644
> index 000000000000..fbab623e6fba
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/mfd/ac100.txt
> @@ -0,0 +1,42 @@
> +X-Powers AC100 Codec/RTC IC device tree bindings
> +
> +AC100 is a audio codec and RTC subsystem combo IC. The 2 parts are
> +separated, including power supplies and interrupt lines, but share
> +a common register address space and host interface.
> +
> +Required properties:
> +- compatible: "x-powers,ac100"
> +- reg: The I2C slave address or RSB hardware address for the chip
> +- sub-nodes:
> + - codec
> + - compatible: "x-powers,ac100-codec"
> + - interrupt-parent: The parent interrupt controller
> + - interrupts: SoC NMI / GPIO interrupt connected to the IRQ_AUDIO pin
> + - rtc
> + - compatible: "x-powers,ac100-rtc"
> + - interrupt-parent: The parent interrupt controller
> + - interrupts: SoC NMI / GPIO interrupt connected to the IRQ_RTC pin
> + - #clock-cells: shall be 1
> + - clock-output-names: "cko1_rtc", "cko2_rtc", "cko3_rtc"
> + - see clock/clock-bindings.txt for common clock bindings
> +
> +Example:
> +
> +ac100: codec@e89 {
> + compatible = "x-powers,ac100";
> + reg = <0xe89>;
> +
> + ac100_codec {
> + compatible = "x-powers,ac100-codec";
> + interrupt-parent = <&nmi_intc>;
> + interrupts = <0 IRQ_TYPE_LEVEL_LOW>;
> + };
> +
> + ac100_rtc {
> + compatible = "x-powers,ac100-rtc";
> + interrupt-parent = <&nmi_intc>;
> + interrupts = <0 IRQ_TYPE_LEVEL_LOW>;

Isn't this the same interrupt as above? Is it shared?

> + #clock-cells = <1>;
> + clock-output-names = "cko1_rtc", "cko2_rtc", "cko3_rtc";
> + };
> +};

--
Lee Jones
Linaro STMicroelectronics Landing Team Lead
Linaro.org │ Open source software for ARM SoCs
Follow Linaro: Facebook | Twitter | Blog

\
 
 \ /
  Last update: 2016-06-15 15:21    [W:0.320 / U:0.224 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site