lkml.org 
[lkml]   [2016]   [May]   [6]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [RFC v2 13/13] ARM: dts: exynos: Fix LAN and HUB after bootloader initialization on Odroid U3
From
Date
On 05/05/2016 10:16 PM, Javier Martinez Canillas wrote:
> Hello Krzysztof,
>
> On 05/05/2016 08:34 AM, Krzysztof Kozlowski wrote:
>> On Odroid U3 (Exynos4412-based) board if USB was initialized by
>> bootloader (in U-Boot "usb start" before tftpboot), the HUB (usb3503)
>> and LAN (smsc95xx) after after successful probing were not visible in the
>> system ("lsusb").
>>
>> In such case the devices had to be fully reset before configuring.
>> Reset by GPIO (called RESET_N pin) and by RESET field in STCD register
>> in usb3503 HUB are not sufficient. Instead full reset has to be done by
>> disabling and enabling regulator.
>>
>> Signed-off-by: Krzysztof Kozlowski <k.kozlowski@samsung.com>
>> ---
>
> [snip]
>
>>
>> + lan_pwrseq: pwrseq2 {
>> + compatible = "mmc-pwrseq-simple";
>
> It feels strange to have a "mmc-pwrseq-simple" compatible for a USB power
> sequence provider. As I mentioned in the other patch, I think there should
> either be a DT binding for the USB pwrseq-simple with a "usb-pwrseq-simple"
> compatible that binds to the same pwrseq-simple driver or maybe having a
> generic DT binding for any device with a new "pwrseq-simple" compatible.
>
> Patch looks good to me though, so after having a DT binding and changing
> the compatible string:
>
> Reviewed-by: Javier Martinez Canillas <javier@osg.samsung.com>

Probably this will change after Rob's feedback. :)

Best regards,
Krzysztof


\
 
 \ /
  Last update: 2016-05-06 08:41    [W:0.055 / U:0.308 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site