Messages in this thread | | | Date | Wed, 01 Jun 2016 10:25:05 +0900 | From | Jaehoon Chung <> | Subject | Re: [PATCH 1/3] mmc: fix mmc mode selection for HS-DDR and higher |
| |
On 05/29/2016 04:04 PM, Chen-Yu Tsai wrote: > When IS_ERR_VALUE was removed from the mmc core code, it was replaced > with a simple not-zero check. This does not work, as the value checked > is the return value for mmc_select_bus_width, which returns the set > bit width on success. This made eMMC modes higher than HS-DDR unusable. > > Fix this by checking for a positive return value instead. > > Fixes: 287980e49ffc ("remove lots of IS_ERR_VALUE abuses") > Cc: Arnd Bergmann <arnd@arndb.de> > Signed-off-by: Chen-Yu Tsai <wens@csie.org>
Acked-by: Jaehoon Chung <jh80.chung@samsung.com>
Best Regards, Jaehoon Chung
> --- > drivers/mmc/core/mmc.c | 4 ++-- > 1 file changed, 2 insertions(+), 2 deletions(-) > > diff --git a/drivers/mmc/core/mmc.c b/drivers/mmc/core/mmc.c > index c984321d1881..aafb73d080ca 100644 > --- a/drivers/mmc/core/mmc.c > +++ b/drivers/mmc/core/mmc.c > @@ -1276,7 +1276,7 @@ static int mmc_select_hs200(struct mmc_card *card) > * switch to HS200 mode if bus width is set successfully. > */ > err = mmc_select_bus_width(card); > - if (!err) { > + if (err > 0) { > val = EXT_CSD_TIMING_HS200 | > card->drive_strength << EXT_CSD_DRV_STR_SHIFT; > err = __mmc_switch(card, EXT_CSD_CMD_SET_NORMAL, > @@ -1583,7 +1583,7 @@ static int mmc_init_card(struct mmc_host *host, u32 ocr, > } else if (mmc_card_hs(card)) { > /* Select the desired bus width optionally */ > err = mmc_select_bus_width(card); > - if (!err) { > + if (err > 0) { > err = mmc_select_hs_ddr(card); > if (err) > goto free_card; >
| |