lkml.org 
[lkml]   [2016]   [May]   [19]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v4 14/14] staging: comedi: daqboard2000: prefer usleep_range()
Date
The checkpatch.pl warns about two `udelay(x)` calls, one of 100
microseconds, and one of 10 microseconds. The 100 microseconds one is
used when waiting for FPGA to become ready to accept firmware, and is
not that critical, so replace it with a call to `usleep_range(100,
1000)`. The 10 microseconds one is called as each 16-bit word of
firmware data is written. Replace it with a fairly tight
`usleep_range(10, 20)` to avoid slowing down firmware loading too much.
The firmware is fairly short, so this would only slow it down firmware
loading by about 20 milliseconds or so.

Signed-off-by: Ian Abbott <abbotti@mev.co.uk>
Reviewed-by: H Hartley Sweeten <hsweeten@visionengravers.com>
---
v2: Replaced the 10 microsecond udelay with a fairly tight usleep_range,
as suggested by Hartley.
v3, v4: No change.
---
drivers/staging/comedi/drivers/daqboard2000.c | 4 ++--
1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/staging/comedi/drivers/daqboard2000.c b/drivers/staging/comedi/drivers/daqboard2000.c
index fd9fb21..b259d41 100644
--- a/drivers/staging/comedi/drivers/daqboard2000.c
+++ b/drivers/staging/comedi/drivers/daqboard2000.c
@@ -476,7 +476,7 @@ static int daqboard2000_poll_cpld(struct comedi_device *dev, int mask)
result = 1;
break;
}
- udelay(100);
+ usleep_range(100, 1000);
}
udelay(5);
return result;
@@ -486,7 +486,7 @@ static int daqboard2000_write_cpld(struct comedi_device *dev, int data)
{
int result = 0;

- udelay(10);
+ usleep_range(10, 20);
writew(data, dev->mmio + 0x1000);
if ((readw(dev->mmio + 0x1000) & DAQBOARD2000_CPLD_INIT) ==
DAQBOARD2000_CPLD_INIT) {
--
2.8.1
\
 
 \ /
  Last update: 2016-05-19 20:41    [W:0.205 / U:0.512 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site