lkml.org 
[lkml]   [2016]   [May]   [17]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH v3] Input - surface3_spi: add new driver for the Surface 3
Hi Benjamin,

On Tue, May 17, 2016 at 12:16:19PM +0200, Benjamin Tissoires wrote:
> This is a basic driver for the Surface 3. I am not so sure it will work
> with any firmwares as most values are encoded, but given that I only have
> access to my current device with its firmware and I don't have the
> datasheet, it should be OK for now.
>
> The Surface Pen is not supported (if it is supposed to be). I'll work on
> this when I get one.
>
> Signed-off-by: Benjamin Tissoires <benjamin.tissoires@redhat.com>
> ---
> Changes in v2:
>
> - module renamed from ntrig_spi to surface3_spi
> - took into account Dmitry's remarks
> - kept the retrieval of the GPIO as mandatory as otherwise the device fails to work
>
> Changes in v3:
>
> - asm include put at the end
> - used proper types in struct surfacae3_ts_data_finger
> - dropped temps in surface3_spi_report_touch()
> - inlined surface3_spi_request_irq()
> - detect IRQ type (falling/rising) depending on the gpiod active low parameter

I do not think that this should be done in the driver. The device either
has interrupt descriptor or GpioInt decriptor in DSDT and SPI core/ACPI
should do the right thing and configure GPIO as input and set interrupt
polarity accordingly, so when you do request_threaded_irq() you only
need to specify IRQF_ONESHOT.

See drivers/spi/spi.c - in case there is no interrupt specified we call
acpi_dev_gpio_irq_get(). Do you see it called in your case? Or your DSDT
has interrupt for the touchscreen device and acpi_spi_add_resource() and
acpi_dev_resource_interrupt() are called? You need to trace it and
figure out if there is an issue there with setting up interrupt
properly.

Thanks.

--
Dmitry

\
 
 \ /
  Last update: 2016-05-17 20:21    [W:0.089 / U:0.752 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site