lkml.org 
[lkml]   [2016]   [May]   [12]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH 6/6] pinctrl: tegra: Add driver to configure voltage and power state of io pads
From
Date

On 11/05/16 17:07, Stephen Warren wrote:
> On 05/11/2016 03:19 AM, Linus Walleij wrote:
>> On Mon, May 2, 2016 at 2:17 PM, Laxman Dewangan <ldewangan@nvidia.com>
>> wrote:
>>
>>> NVIDIA Tegra210 supports the IO pads which can operate at 1.8V
>>> or 3.3V I/O voltage levels. Also the IO pads can be configured
>>> for power down state if it is not used. SW needs to configure the
>>> voltage level of IO pads based on IO rail voltage and its power
>>> state based on platform usage.
>>>
>>> The voltage and power state configurations of pads are provided
>>> through pin control frameworks. Add pin control driver for Tegra's
>>> IO pads' voltage and power state configurations.
>>>
>>> Signed-off-by: Laxman Dewangan <ldewangan@nvidia.com>
>>>
>>> ---
>>> Changes from V1:
>>> - Use the generic pincontrol property for low power enable/disable.
>>> - sync with latest and remove all MODULE* macros
>>> - Use renamed APIs form PMC
>>
>> Looks OK to me, need Stephen's ACK though!
>
> This driver is for HW that's separate from the main Tegra pinmux module.
> Thierry Reding and Jon Hunter are more appropriate reviewers for this one.

There will be another spin of this, so let's wait for the V2.

Cheers
Jon

\
 
 \ /
  Last update: 2016-05-12 12:41    [W:0.061 / U:0.556 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site