lkml.org 
[lkml]   [2016]   [Apr]   [6]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH net-next 2/3] net: dsa: make the FDB add function return void
On Tue, Apr 05, 2016 at 11:14:54PM -0400, Vivien Didelot wrote:
> Hi Andrew,
>
> Andrew Lunn <andrew@lunn.ch> writes:
>
> >> mutex_lock(&ps->smi_mutex);
> >> - ret = _mv88e6xxx_port_fdb_load(ds, port, fdb->addr, fdb->vid, state);
> >> + if (_mv88e6xxx_port_fdb_load(ds, port, fdb->addr, fdb->vid, state))
> >> + netdev_warn(ds->ports[port], "cannot load address\n");
> >
> > In the SF2 driver you use pr_err, but here netdev_warn. We probably
> > should be consistent if we error or warn. I would use netdev_error,
> > since if this fails we probably have a real hardware problem.
>
> I used pr_err in the SF2 driver to be consistent with the rest of the
> code which only uses pr_err and pr_info.

O.K, good.

> I was thinking about adding ds_err and ds_port_err to print errors for
> ds->master_dev and ds->ports[port], but that might be overkill.

I'm also trying to kill off the use of ds within the mv88e6xxx driver.

> What do you think? Or local to the driver for the moment, like
> mvsw_err maybe?

I would keep it local. Also, for this sort of error, it does not need
to differentiate on port. It is a hardware access error, something is
wrong with the mdio bus/switch. So i would even put the message in the
very low level reg_read/reg_write functions, and no where else.

Andrew

\
 
 \ /
  Last update: 2016-04-06 15:21    [W:0.345 / U:0.116 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site