Messages in this thread | | | Date | Wed, 20 Apr 2016 16:43:24 +0200 | Subject | Re: [PATCH 6/8] mfd: Add STMPE1600 support | From | Linus Walleij <> |
| |
On Tue, Apr 19, 2016 at 2:18 PM, <patrice.chotard@st.com> wrote:
> From: Patrice Chotard <patrice.chotard@st.com> > > STMPE1600 is a 16-bit port expander. > Datasheet is available here : > http://www2.st.com/content/st_com/en/products/interfaces-and-transceivers/ > i-o-expanders-and-level-translators/i-o-expanders/stmpe1600.html > > As STMPE1600's SYS_CTRL register has the same layout as > STMPE801 variant, unify STMPExxx_REG_SYS_CTRL_RESET/INT_EN/INT_HI > bit masks to more generic STMPE_SYS_CTRL_RESET/INT_EN/INT_HI > > Signed-off-by: Amelie DELAUNAY <amelie.delaunay@st.com> > Signed-off-by: Patrice Chotard <patrice.chotard@st.com>
(...) > #define STMPE_SYS_CTRL_RESET (1 << 7) > +#define STMPE_SYS_CTRL_INT_EN (1 << 2) > +#define STMPE_SYS_CTRL_INT_HI (1 << 0) > > /* > * STMPE801 > @@ -121,10 +123,6 @@ int stmpe_remove(struct stmpe *stmpe); > #define STMPE801_REG_GPIO_SET_PIN 0x11 > #define STMPE801_REG_GPIO_DIR 0x12 > > -#define STMPE801_REG_SYS_CTRL_RESET (1 << 7) > -#define STMPE801_REG_SYS_CTRL_INT_EN (1 << 2) > -#define STMPE801_REG_SYS_CTRL_INT_HI (1 << 0)
This looks like unrelated cleanups? Should this be in the reset enablement patch? (It's OK with me though.)
With that fixed: Acked-by: Linus Walleij <linus.walleij@linaro.org>
Yours, Linus Walleij
| |