lkml.org 
[lkml]   [2016]   [Apr]   [12]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH 04/15] irqchip/gic: WARN if setting the interrupt type fails
From
Date
On 12/04/16 09:50, Jon Hunter wrote:
>
> On 11/04/16 16:39, Marc Zyngier wrote:
>> On 11/04/16 16:31, Jon Hunter wrote:
>>> On 09/04/16 11:58, Marc Zyngier wrote:
>
> [snip]
>
>>>> I think we need to phase things. Let's start with warning people for a
>>>> few kernel releases. Actively maintained platforms will quickly address
>>>> the issue (fixing their DT). As I see it, this issue seems rather
>>>> widespread (even kvmtool outputs a DT with the wrong triggering
>>>> information).
>>>>
>>>> Once we've fixed the bulk of the platforms and virtual environments, we
>>>> can start thinking about making it fail harder.
>>>
>>> Ok, so are you OK with this patch as-is? If so, can I add your ACK?
>>
>> It depends where you plan to handle the error. Ideally, I'd keep on
>> returning the error (because that's the right thing to do), and move the
>> WARN_ON() into the core code. We'd keep on ignoring the error as we're
>> doing today, but we'd scream about it.
>>
>> After a couple of releases, we'd turn the WARN_ON into a hard fail.
>>
>> Thoughts?
>
> I agree that would be best/ideal, but looking at it, I don't believe it
> is possible and this is why I have not done that so far.
>
> If we were to add the WARN to the core code, then we would need to add a
> warning everywhere __irq_set_trigger() is called. One of the places it
> is called today is from __setup_irq() and today this does the right
> thing and handle any error returned. The problem is that in
> irq_create_fwspec_mapping() we have never checked the return code from
> irq_set_irq_type() (which calls __irq_set_trigger()) or attempted to
> handle any errors. So the problem is that depending on the path through
> which the type is programmed, errors may or may not be detected. This is
> the actual headache :-(
>
> Given that this problem so far only pertains to GIC PPI interrupts and
> that it is a not a catastrophic error (interrupts still work fine), I
> was thinking we add the warning to the GIC driver.
>
> May be a less severe change would be to only return an error if
> configuring an SPI fails and if it is a PPI then simply WARN and
> carry-on as we assume we cannot change it.

I'd take that. Limiting it to PPIs would be a minimal change, and the
warning would hopefully make people realize their DT is wrong. Failing
to program an SPI is really not expected, and should definitely explode.

Thanks,

M.
--
Jazz is not dead. It just smells funny...

\
 
 \ /
  Last update: 2016-04-12 12:41    [W:1.006 / U:0.232 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site