lkml.org 
[lkml]   [2016]   [Mar]   [23]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: regmap: mmio: regression in pre-v4.6-rc1
On Wed, Mar 23, 2016 at 12:16:13PM +0100, Alexander Stein wrote:
> On Wednesday 23 March 2016 10:34:15, Mark Brown wrote:

> > Are you *sure* that this is actually big endian? Are you basing this on
> > documentation or on what happened to work for you in the past.

> Please refer to QorIQ LS1021A Reference Manual (REV 0) table 2.2 (CCSR block
> base address map) which states that this peripheral (among _most_ but not all)
> requires byte swapping. Same for DSPI.
> Yeah, it sounds strange.

I don't have that document.

> > Have you tried tracing through the code to see what ends up happening to
> > the I/O? It should come out using your architecture's big endian
> > accessors.

> In regmap_mmio_gen_context ctx->reg_read is set to regmap_mmio_read32le and
> ctx->reg_write to regmap_mmio_write32le respectively.

So how does that happen then? We set these values if the bus is
default, little or native endian but if it's big endian we go into a
completely different case...
[unhandled content-type:application/pgp-signature]
\
 
 \ /
  Last update: 2016-03-23 13:21    [W:0.055 / U:0.456 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site