lkml.org 
[lkml]   [2016]   [Feb]   [4]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
    Patch in this message
    /
    From
    Subject[RFC PATCH 16/19] ide: remove deprecated slc90e66 host driver
    Date
    IDE subsystem has been deprecated since 2009 and the majority
    (if not all) of Linux distributions have switched to use
    libata for ATA support exclusively.

    The replacement driver (pata_efar) has been available since
    2006 and it supports all the hardware supported by the old
    slc90e66 host driver.

    Remove the deprecated slc90e66 host driver.

    Signed-off-by: Bartlomiej Zolnierkiewicz <b.zolnierkie@samsung.com>
    ---
    drivers/ide/Kconfig | 13 ----
    drivers/ide/Makefile | 1 -
    drivers/ide/slc90e66.c | 181 -------------------------------------------------
    3 files changed, 195 deletions(-)
    delete mode 100644 drivers/ide/slc90e66.c

    diff --git a/drivers/ide/Kconfig b/drivers/ide/Kconfig
    index d086f52..c92d5d1 100644
    --- a/drivers/ide/Kconfig
    +++ b/drivers/ide/Kconfig
    @@ -454,19 +454,6 @@ config BLK_DEV_SL82C105
    special configuration for this chip. This is common on various CHRP
    motherboards, but could be used elsewhere. If in doubt, say Y.

    -config BLK_DEV_SLC90E66
    - tristate "SLC90E66 chipset support"
    - select BLK_DEV_IDEDMA_PCI
    - help
    - This driver ensures (U)DMA support for Victory66 SouthBridges for
    - SMsC with Intel NorthBridges. This is an Ultra66 based chipset.
    - The nice thing about it is that you can mix Ultra/DMA/PIO devices
    - and it will handle timing cycles. Since this is an improved
    - look-a-like to the PIIX4 it should be a nice addition.
    -
    - Please read the comments at the top of
    - <file:drivers/ide/slc90e66.c>.
    -
    config BLK_DEV_TRM290
    tristate "Tekram TRM290 chipset support"
    select BLK_DEV_IDEDMA_PCI
    diff --git a/drivers/ide/Makefile b/drivers/ide/Makefile
    index 3867f7d..1ff2f8a 100644
    --- a/drivers/ide/Makefile
    +++ b/drivers/ide/Makefile
    @@ -47,7 +47,6 @@ obj-$(CONFIG_BLK_DEV_PIIX) += piix.o
    obj-$(CONFIG_BLK_DEV_SGIIOC4) += sgiioc4.o
    obj-$(CONFIG_BLK_DEV_SIIMAGE) += siimage.o
    obj-$(CONFIG_BLK_DEV_SL82C105) += sl82c105.o
    -obj-$(CONFIG_BLK_DEV_SLC90E66) += slc90e66.o
    obj-$(CONFIG_BLK_DEV_TC86C001) += tc86c001.o
    obj-$(CONFIG_BLK_DEV_TRIFLEX) += triflex.o
    obj-$(CONFIG_BLK_DEV_TRM290) += trm290.o
    diff --git a/drivers/ide/slc90e66.c b/drivers/ide/slc90e66.c
    deleted file mode 100644
    index 8af92bb..0000000
    --- a/drivers/ide/slc90e66.c
    +++ /dev/null
    @@ -1,181 +0,0 @@
    -/*
    - * Copyright (C) 2000-2002 Andre Hedrick <andre@linux-ide.org>
    - * Copyright (C) 2006-2007 MontaVista Software, Inc. <source@mvista.com>
    - *
    - * This is a look-alike variation of the ICH0 PIIX4 Ultra-66,
    - * but this keeps the ISA-Bridge and slots alive.
    - *
    - */
    -
    -#include <linux/types.h>
    -#include <linux/module.h>
    -#include <linux/kernel.h>
    -#include <linux/pci.h>
    -#include <linux/ide.h>
    -#include <linux/init.h>
    -
    -#define DRV_NAME "slc90e66"
    -
    -static DEFINE_SPINLOCK(slc90e66_lock);
    -
    -static void slc90e66_set_pio_mode(ide_hwif_t *hwif, ide_drive_t *drive)
    -{
    - struct pci_dev *dev = to_pci_dev(hwif->dev);
    - int is_slave = drive->dn & 1;
    - int master_port = hwif->channel ? 0x42 : 0x40;
    - int slave_port = 0x44;
    - unsigned long flags;
    - u16 master_data;
    - u8 slave_data;
    - int control = 0;
    - const u8 pio = drive->pio_mode - XFER_PIO_0;
    -
    - /* ISP RTC */
    - static const u8 timings[][2] = {
    - { 0, 0 },
    - { 0, 0 },
    - { 1, 0 },
    - { 2, 1 },
    - { 2, 3 }, };
    -
    - spin_lock_irqsave(&slc90e66_lock, flags);
    - pci_read_config_word(dev, master_port, &master_data);
    -
    - if (pio > 1)
    - control |= 1; /* Programmable timing on */
    - if (drive->media == ide_disk)
    - control |= 4; /* Prefetch, post write */
    - if (ide_pio_need_iordy(drive, pio))
    - control |= 2; /* IORDY */
    - if (is_slave) {
    - master_data |= 0x4000;
    - master_data &= ~0x0070;
    - if (pio > 1) {
    - /* Set PPE, IE and TIME */
    - master_data |= control << 4;
    - }
    - pci_read_config_byte(dev, slave_port, &slave_data);
    - slave_data &= hwif->channel ? 0x0f : 0xf0;
    - slave_data |= ((timings[pio][0] << 2) | timings[pio][1]) <<
    - (hwif->channel ? 4 : 0);
    - } else {
    - master_data &= ~0x3307;
    - if (pio > 1) {
    - /* enable PPE, IE and TIME */
    - master_data |= control;
    - }
    - master_data |= (timings[pio][0] << 12) | (timings[pio][1] << 8);
    - }
    - pci_write_config_word(dev, master_port, master_data);
    - if (is_slave)
    - pci_write_config_byte(dev, slave_port, slave_data);
    - spin_unlock_irqrestore(&slc90e66_lock, flags);
    -}
    -
    -static void slc90e66_set_dma_mode(ide_hwif_t *hwif, ide_drive_t *drive)
    -{
    - struct pci_dev *dev = to_pci_dev(hwif->dev);
    - u8 maslave = hwif->channel ? 0x42 : 0x40;
    - int sitre = 0, a_speed = 7 << (drive->dn * 4);
    - int u_speed = 0, u_flag = 1 << drive->dn;
    - u16 reg4042, reg44, reg48, reg4a;
    - const u8 speed = drive->dma_mode;
    -
    - pci_read_config_word(dev, maslave, &reg4042);
    - sitre = (reg4042 & 0x4000) ? 1 : 0;
    - pci_read_config_word(dev, 0x44, &reg44);
    - pci_read_config_word(dev, 0x48, &reg48);
    - pci_read_config_word(dev, 0x4a, &reg4a);
    -
    - if (speed >= XFER_UDMA_0) {
    - u_speed = (speed - XFER_UDMA_0) << (drive->dn * 4);
    -
    - if (!(reg48 & u_flag))
    - pci_write_config_word(dev, 0x48, reg48|u_flag);
    - if ((reg4a & a_speed) != u_speed) {
    - pci_write_config_word(dev, 0x4a, reg4a & ~a_speed);
    - pci_read_config_word(dev, 0x4a, &reg4a);
    - pci_write_config_word(dev, 0x4a, reg4a|u_speed);
    - }
    - } else {
    - const u8 mwdma_to_pio[] = { 0, 3, 4 };
    -
    - if (reg48 & u_flag)
    - pci_write_config_word(dev, 0x48, reg48 & ~u_flag);
    - if (reg4a & a_speed)
    - pci_write_config_word(dev, 0x4a, reg4a & ~a_speed);
    -
    - if (speed >= XFER_MW_DMA_0)
    - drive->pio_mode =
    - mwdma_to_pio[speed - XFER_MW_DMA_0] + XFER_PIO_0;
    - else
    - drive->pio_mode = XFER_PIO_2; /* for SWDMA2 */
    -
    - slc90e66_set_pio_mode(hwif, drive);
    - }
    -}
    -
    -static u8 slc90e66_cable_detect(ide_hwif_t *hwif)
    -{
    - struct pci_dev *dev = to_pci_dev(hwif->dev);
    - u8 reg47 = 0, mask = hwif->channel ? 0x01 : 0x02;
    -
    - pci_read_config_byte(dev, 0x47, &reg47);
    -
    - /* bit[0(1)]: 0:80, 1:40 */
    - return (reg47 & mask) ? ATA_CBL_PATA40 : ATA_CBL_PATA80;
    -}
    -
    -static const struct ide_port_ops slc90e66_port_ops = {
    - .set_pio_mode = slc90e66_set_pio_mode,
    - .set_dma_mode = slc90e66_set_dma_mode,
    - .cable_detect = slc90e66_cable_detect,
    -};
    -
    -static const struct ide_port_info slc90e66_chipset = {
    - .name = DRV_NAME,
    - .enablebits = { {0x41, 0x80, 0x80}, {0x43, 0x80, 0x80} },
    - .port_ops = &slc90e66_port_ops,
    - .pio_mask = ATA_PIO4,
    - .swdma_mask = ATA_SWDMA2_ONLY,
    - .mwdma_mask = ATA_MWDMA12_ONLY,
    - .udma_mask = ATA_UDMA4,
    -};
    -
    -static int slc90e66_init_one(struct pci_dev *dev,
    - const struct pci_device_id *id)
    -{
    - return ide_pci_init_one(dev, &slc90e66_chipset, NULL);
    -}
    -
    -static const struct pci_device_id slc90e66_pci_tbl[] = {
    - { PCI_VDEVICE(EFAR, PCI_DEVICE_ID_EFAR_SLC90E66_1), 0 },
    - { 0, },
    -};
    -MODULE_DEVICE_TABLE(pci, slc90e66_pci_tbl);
    -
    -static struct pci_driver slc90e66_pci_driver = {
    - .name = "SLC90e66_IDE",
    - .id_table = slc90e66_pci_tbl,
    - .probe = slc90e66_init_one,
    - .remove = ide_pci_remove,
    - .suspend = ide_pci_suspend,
    - .resume = ide_pci_resume,
    -};
    -
    -static int __init slc90e66_ide_init(void)
    -{
    - return ide_pci_register_driver(&slc90e66_pci_driver);
    -}
    -
    -static void __exit slc90e66_ide_exit(void)
    -{
    - pci_unregister_driver(&slc90e66_pci_driver);
    -}
    -
    -module_init(slc90e66_ide_init);
    -module_exit(slc90e66_ide_exit);
    -
    -MODULE_AUTHOR("Andre Hedrick");
    -MODULE_DESCRIPTION("PCI driver module for SLC90E66 IDE");
    -MODULE_LICENSE("GPL");
    --
    1.9.1
    \
     
     \ /
      Last update: 2016-02-04 15:21    [W:2.085 / U:0.644 seconds]
    ©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site