Messages in this thread | | | From | Krzysztof Adamski <> | Subject | [PATCH v5 0/4] pinctrl: sunxi: Add H3 R_PIO controller support | Date | Mon, 22 Feb 2016 14:03:24 +0100 |
| |
This patch series is extension of my original single patch with the same subject. It adds support for R_PIO so that GPIO port L can be used in H3 based devices. It was tested on OrangePi PC and OrangePi Plus where PL is connected amount others to an onboard led, a switch, an IR receiver and some VCC controllers.
Patchset is based on next-20160222.
---
Changes since v4: - remove patches that are alredy merged - add patch describing leds and switch in DT
Changes since v3: - collect some acked-bys - fix r_pios #interrupt-cells
Changes since v2: - fixed apb0 parrent clocks list - moved binding documentation change to the proper patch - simplified sunxi_pinctrl_gpio_get according to ChenYu suggestions - fixed ordering in sunxi binding documentation
Changes since v1: - splited patch to two separate - dtsi and c files - added APB0 clocks a parent for R_PIO - added fix in sunxi_pinctrl_gpio_get for getting pin value when in irq mode and on 2nd pinctrl - fixed a "pwn" > "pwm" typo - fixed order in allwinner,sunxi-pinctrl.txt
Krzysztof Adamski (4): clk: sunxi: Add apb0 gates for H3 dts: sun8i-h3: Add APB0 related clocks and resets ARM: dts: sun8i-h3: Add R_PIO controller node to the dtsi ARM: dts: sun8i: Add leds and switch on Orangepi Plus boards
Krzysztof Adamski (4): clk: sunxi: Add apb0 gates for H3 dts: sun8i-h3: Add APB0 related clocks and resets ARM: dts: sun8i-h3: Add R_PIO controller node to the dtsi ARM: dts: sun8i: Add leds and switch on Orangepi Plus boards
Documentation/devicetree/bindings/clock/sunxi.txt | 2 + arch/arm/boot/dts/sun8i-h3-orangepi-plus.dts | 63 +++++++++++++++++++++++ arch/arm/boot/dts/sun8i-h3.dtsi | 37 +++++++++++++ drivers/clk/sunxi/clk-simple-gates.c | 4 ++ 4 files changed, 106 insertions(+)
-- 2.1.4
| |