lkml.org 
[lkml]   [2016]   [Feb]   [11]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
SubjectRe: [PATCH] gpio: add tps65218 gpio
From
On Sat, Jan 30, 2016 at 6:06 PM, Nicolas Saenz Julienne
<nicolassaenzj@gmail.com> wrote:

> Driver for the GPIO block found in ti's tps65218 pmics.
>
> The device has two GPIOs and one GPO pin which can be configured as follows:
> GPIO1:
> -general-purpose, open-drain output controlled by GPO1 user bit and/or
> sequencer
> -DDR3 reset input signal from SOC. Signal is either latched or
> passed-trough to GPO2 pin. See below for details.
> GPO2:
> -general-purpose output controlled by GPO2 user bit
> -DDR3 reset output signal. Signal is controlled by GPIO1 and PGOOD.
> See below for details.
> -Output buffer can be configured as open-drain or push-pull.
> GPIO3:
> -general-purpose, open-drain output controlled by GPO3 user bit and/or
> sequencer
> -reset input-signal for DCDC1 and DCDC2.
>
> The input configurations are not meant to be used by the user so the driver
> only offers GPOs.
>
> v2: Added request routine that evaluates the fw config flags and removed module
> owner
> v3: Added .direction_input() routine, and took care of all Linus Walleij
> suggestions (clamp to bool, use proper include)
>
> Signed-off-by: Nicolas Saenz Julienne <nicolassaenzj@gmail.com>

OK nice! Patch applied.

Yours,
Linus Walleij

\
 
 \ /
  Last update: 2016-02-11 12:41    [W:0.043 / U:0.740 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site