lkml.org 
[lkml]   [2016]   [Nov]   [26]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Date
SubjectRe: [PATCH v3 net-next 1/2] net: ethernet: slicoss: add slicoss gigabit ethernet driver
Hi, Lino,

...

> @@ -0,0 +1,28 @@
> +config NET_VENDOR_ALACRITECH
> + bool "Alacritech devices"
> + default y
> + ---help---
> + If you have a network (Ethernet) card belonging to this class, say Y.
> +
> + Note that the answer to this question doesn't directly affect the
> + kernel: saying N will just cause the configurator to skip all

Shouldn't it be "Alacritech devices" here, as appears earlier ?

> + the questions about Renesas devices. If you say Y, you will be asked
> + for your specific device in the following questions.
> +

...
...
...
> +struct slic_device {
> + struct pci_dev *pdev;
...
> + bool promisc;

Seems that the autoneg boolean is not used anywhere, apart from
setting it once to true in
the slic_set_link_autoneg() method. Apart from this member it is not
accessed anywhere, so it seems it should be removed.

> + bool autoneg;
> + int speed;
...
...

> +static int slic_load_rcvseq_firmware(struct slic_device *sdev)
> +{
> + const struct firmware *fw;
> + const char *file;
> + u32 codelen;
> + int idx = 0;
> + u32 instr;
> + u32 addr;
> + int err;
> +
...
> + /* Do an initial sanity check concerning firmware size now. A further
> + * check follows below.
> + */
> + if (fw->size < SLIC_FIRMWARE_MIN_SIZE) {
> + dev_err(&sdev->pdev->dev,
> + "invalid firmware size %zu (min %u expected)\n",
> + fw->size, SLIC_FIRMWARE_MIN_SIZE);
> + err = -EINVAL;

in the release label, always 0 is returned:

> + goto release;
> + }
> +
> + codelen = slic_read_dword_from_firmware(fw, &idx);
> +
> + /* do another sanity check against firmware size */
> + if ((codelen + 4) > fw->size) {
> + dev_err(&sdev->pdev->dev,
> + "invalid rcv-sequencer firmware size %zu\n", fw->size);
> + err = -EINVAL;

Again, in the release label, always 0 is returned:

> + goto release;
> + }
> +
>
> +release:
> + release_firmware(fw);
> +
> + return 0;
> +}
> +

Regards,
Rami Rosen

\
 
 \ /
  Last update: 2016-11-26 16:49    [W:0.202 / U:0.240 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site