lkml.org 
[lkml]   [2016]   [Nov]   [15]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Date
SubjectRe: [PATCH V2 2/2] pinctrl: tegra: Add driver to configure voltage and power of io pads
On Wed, Nov 9, 2016 at 2:06 PM, Laxman Dewangan <ldewangan@nvidia.com> wrote:

> NVIDIA Tegra124 and later SoCs support the multi-voltage level and
> low power state of some of its IO pads. The IO pads can work in
> the voltage of the 1.8V and 3.3V of IO voltage from IO power rail
> sources. When IO interfaces are not used then IO pads can be
> configure in low power state to reduce the power consumption from
> that IO pads.
>
> On Tegra124, the voltage level of IO power rail source is auto
> detected by hardware(SoC) and hence it is only require to configure
> in low power mode if IO pads are not used.
>
> On T210 onwards, the auto-detection of voltage level from IO power
> rail is removed from SoC and hence SW need to configure the PMC
> register explicitly to set proper voltage in IO pads based on
> IO rail power source voltage.
>
> This driver adds the IO pad driver to configure the power state and
> IO pad voltage based on the usage and power tree via pincontrol
> framework. The configuration can be static and dynamic.
>
> Signed-off-by: Laxman Dewangan <ldewangan@nvidia.com>
>
> ---
> Changes from V1:
> - Dropped the custom properties to set pad voltage and use regulator.
> - Added support for regulator to get vottage in boot and configure IO
> pad voltage.
> - Add support for callback to handle regulator notification and configure
> IO pad voltage based on voltage change.

I'm waiting for maintainer review on this.
Stephen/Thierry?

Yours,
Linus Walleij

\
 
 \ /
  Last update: 2016-11-15 10:00    [W:0.217 / U:0.116 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site