lkml.org 
[lkml]   [2016]   [Oct]   [19]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH] mtd: nand: Add OX820 NAND Support
Date
Add NAND driver to support the Oxford Semiconductor OX820 NAND Controller.
This is a simple memory mapped NAND controller with single chip select and
software ECC.

Signed-off-by: Neil Armstrong <narmstrong@baylibre.com>
---
.../devicetree/bindings/mtd/oxnas-nand.txt | 24 +++
drivers/mtd/nand/Kconfig | 5 +
drivers/mtd/nand/Makefile | 1 +
drivers/mtd/nand/oxnas_nand.c | 204 +++++++++++++++++++++
4 files changed, 234 insertions(+)
create mode 100644 Documentation/devicetree/bindings/mtd/oxnas-nand.txt
create mode 100644 drivers/mtd/nand/oxnas_nand.c

Changes since RFC http://lkml.kernel.org/r/20161018090927.1990-1-narmstrong@baylibre.com :
- Avoid using chip->IO_ADDR*
- Use new DT structure
- Assign a chip for the subnode
- Use the nand_hw_control structure
- Cleanup probe
- Cleanup cmd_ctrl by using a context ctrl offset used in write_bytes

diff --git a/Documentation/devicetree/bindings/mtd/oxnas-nand.txt b/Documentation/devicetree/bindings/mtd/oxnas-nand.txt
new file mode 100644
index 0000000..83b684d
--- /dev/null
+++ b/Documentation/devicetree/bindings/mtd/oxnas-nand.txt
@@ -0,0 +1,24 @@
+* Oxford Semiconductor OXNAS NAND Controller
+
+Please refer to nand.txt for generic information regarding MTD NAND bindings.
+
+Required properties:
+ - compatible: "oxsemi,ox820-nand"
+ - reg: Base address and length for NAND mapped memory.
+
+Optional Properties:
+ - clocks: phandle to the NAND gate clock if needed.
+ - resets: phandle to the NAND reset control if needed.
+
+Example:
+
+nand: nand@41000000 {
+ compatible = "oxsemi,ox820-nand";
+ reg = <0x41000000 0x100000>;
+ nand-ecc-mode = "soft";
+ clocks = <&stdclk CLK_820_NAND>;
+ resets = <&reset RESET_NAND>;
+ #address-cells = <1>;
+ #size-cells = <1>;
+ status = "disabled";
+};
diff --git a/drivers/mtd/nand/Kconfig b/drivers/mtd/nand/Kconfig
index 7b7a887..c023125 100644
--- a/drivers/mtd/nand/Kconfig
+++ b/drivers/mtd/nand/Kconfig
@@ -426,6 +426,11 @@ config MTD_NAND_ORION
No board specific support is done by this driver, each board
must advertise a platform_device for the driver to attach.

+config MTD_NAND_OXNAS
+ tristate "NAND Flash support for Oxford Semiconductor SoC"
+ help
+ This enables the NAND flash controller on Oxford Semiconductor SoCs.
+
config MTD_NAND_FSL_ELBC
tristate "NAND support for Freescale eLBC controllers"
depends on FSL_SOC
diff --git a/drivers/mtd/nand/Makefile b/drivers/mtd/nand/Makefile
index cafde6f..05fc054 100644
--- a/drivers/mtd/nand/Makefile
+++ b/drivers/mtd/nand/Makefile
@@ -35,6 +35,7 @@ obj-$(CONFIG_MTD_NAND_TMIO) += tmio_nand.o
obj-$(CONFIG_MTD_NAND_PLATFORM) += plat_nand.o
obj-$(CONFIG_MTD_NAND_PASEMI) += pasemi_nand.o
obj-$(CONFIG_MTD_NAND_ORION) += orion_nand.o
+obj-$(CONFIG_MTD_NAND_OXNAS) += oxnas_nand.o
obj-$(CONFIG_MTD_NAND_FSL_ELBC) += fsl_elbc_nand.o
obj-$(CONFIG_MTD_NAND_FSL_IFC) += fsl_ifc_nand.o
obj-$(CONFIG_MTD_NAND_FSL_UPM) += fsl_upm.o
diff --git a/drivers/mtd/nand/oxnas_nand.c b/drivers/mtd/nand/oxnas_nand.c
new file mode 100644
index 0000000..a9fe1ac
--- /dev/null
+++ b/drivers/mtd/nand/oxnas_nand.c
@@ -0,0 +1,204 @@
+/*
+ * Oxford Semiconductor OXNAS NAND driver
+
+ * Copyright (C) 2016 Neil Armstrong <narmstrong@baylibre.com>
+ * Heavily based on plat_nand.c :
+ * Author: Vitaly Wool <vitalywool@gmail.com>
+ * Copyright (C) 2013 Ma Haijun <mahaijuns@gmail.com>
+ * Copyright (C) 2012 John Crispin <blogic@openwrt.org>
+ *
+ * This program is free software; you can redistribute it and/or modify
+ * it under the terms of the GNU General Public License version 2 as
+ * published by the Free Software Foundation.
+ *
+ */
+
+#include <linux/err.h>
+#include <linux/io.h>
+#include <linux/module.h>
+#include <linux/platform_device.h>
+#include <linux/slab.h>
+#include <linux/clk.h>
+#include <linux/reset.h>
+#include <linux/mtd/mtd.h>
+#include <linux/mtd/nand.h>
+#include <linux/mtd/partitions.h>
+#include <linux/of.h>
+
+/* Nand commands */
+#define OXNAS_NAND_CMD_ALE BIT(18)
+#define OXNAS_NAND_CMD_CLE BIT(19)
+
+#define OXNAS_NAND_MAX_CHIPS 1
+
+struct oxnas_nand {
+ struct nand_hw_control base;
+ void __iomem *io_base;
+ struct clk *clk;
+ struct nand_chip *chips[OXNAS_NAND_MAX_CHIPS];
+ unsigned long ctrl;
+};
+
+static uint8_t oxnas_nand_read_byte(struct mtd_info *mtd)
+{
+ struct nand_chip *chip = mtd_to_nand(mtd);
+ struct oxnas_nand *oxnas = nand_get_controller_data(chip);
+
+ return readb(oxnas->io_base);
+}
+
+static void oxnas_nand_read_buf(struct mtd_info *mtd, uint8_t *buf, int len)
+{
+ struct nand_chip *chip = mtd_to_nand(mtd);
+ struct oxnas_nand *oxnas = nand_get_controller_data(chip);
+
+ ioread8_rep(oxnas->io_base, buf, len);
+}
+
+static void oxnas_nand_write_buf(struct mtd_info *mtd,
+ const uint8_t *buf, int len)
+{
+ struct nand_chip *chip = mtd_to_nand(mtd);
+ struct oxnas_nand *oxnas = nand_get_controller_data(chip);
+
+ iowrite8_rep(oxnas->io_base + oxnas->ctrl, buf, len);
+}
+
+/* Single CS command control */
+static void oxnas_nand_cmd_ctrl(struct mtd_info *mtd, int cmd,
+ unsigned int ctrl)
+{
+ struct nand_chip *chip = mtd_to_nand(mtd);
+ struct oxnas_nand *oxnas = nand_get_controller_data(chip);
+
+ if (ctrl & NAND_CTRL_CHANGE) {
+ if (ctrl & NAND_CLE)
+ oxnas->ctrl = OXNAS_NAND_CMD_CLE;
+ else if (ctrl & NAND_ALE)
+ oxnas->ctrl = OXNAS_NAND_CMD_ALE;
+ else
+ oxnas->ctrl = 0;
+ }
+
+ if (cmd != NAND_CMD_NONE)
+ writeb(cmd, oxnas->io_base + oxnas->ctrl);
+}
+
+/*
+ * Probe for the NAND device.
+ */
+static int oxnas_nand_probe(struct platform_device *pdev)
+{
+ struct device_node *np = pdev->dev.of_node;
+ struct device_node *nand_np;
+ struct oxnas_nand *oxnas;
+ struct nand_chip *chip;
+ struct mtd_info *mtd;
+ struct resource *res;
+ int nchips = 0;
+ int count = 0;
+ int err = 0;
+
+ /* Allocate memory for the device structure (and zero it) */
+ oxnas = devm_kzalloc(&pdev->dev, sizeof(struct nand_chip),
+ GFP_KERNEL);
+ if (!oxnas)
+ return -ENOMEM;
+
+ nand_hw_control_init(&oxnas->base);
+
+ res = platform_get_resource(pdev, IORESOURCE_MEM, 0);
+ oxnas->io_base = devm_ioremap_resource(&pdev->dev, res);
+ if (IS_ERR(oxnas->io_base))
+ return PTR_ERR(oxnas->io_base);
+
+ oxnas->clk = devm_clk_get(&pdev->dev, NULL);
+ if (IS_ERR(oxnas->clk))
+ oxnas->clk = NULL;
+
+ /* Only a single chip node is supported */
+ count = of_get_child_count(np);
+ if (count > 1)
+ return -EINVAL;
+
+ clk_prepare_enable(oxnas->clk);
+ device_reset_optional(&pdev->dev);
+
+ for_each_child_of_node(np, nand_np) {
+ chip = devm_kzalloc(&pdev->dev, sizeof(struct nand_chip),
+ GFP_KERNEL);
+ if (!chip)
+ return -ENOMEM;
+
+ chip->controller = &oxnas->base;
+
+ nand_set_flash_node(chip, nand_np);
+ nand_set_controller_data(chip, oxnas);
+
+ mtd = nand_to_mtd(chip);
+ mtd->dev.parent = &pdev->dev;
+ mtd->priv = chip;
+
+ chip->cmd_ctrl = oxnas_nand_cmd_ctrl;
+ chip->read_buf = oxnas_nand_read_buf;
+ chip->read_byte = oxnas_nand_read_byte;
+ chip->write_buf = oxnas_nand_write_buf;
+ chip->chip_delay = 30;
+
+ /* Scan to find existence of the device */
+ err = nand_scan(mtd, 1);
+ if (err)
+ return err;
+
+ err = mtd_device_register(mtd, NULL, 0);
+ if (err) {
+ nand_release(mtd);
+ return err;
+ }
+
+ oxnas->chips[nchips] = chip;
+ ++nchips;
+ }
+
+ /* Exit if no chips found */
+ if (!nchips)
+ return -ENODEV;
+
+ platform_set_drvdata(pdev, oxnas);
+
+ return 0;
+}
+
+static int oxnas_nand_remove(struct platform_device *pdev)
+{
+ struct oxnas_nand *oxnas = platform_get_drvdata(pdev);
+
+ if (oxnas->chips[0])
+ nand_release(nand_to_mtd(oxnas->chips[0]));
+
+ clk_disable_unprepare(oxnas->clk);
+
+ return 0;
+}
+
+static const struct of_device_id oxnas_nand_match[] = {
+ { .compatible = "oxsemi,ox820-nand" },
+ {},
+};
+MODULE_DEVICE_TABLE(of, oxnas_nand_match);
+
+static struct platform_driver oxnas_nand_driver = {
+ .probe = oxnas_nand_probe,
+ .remove = oxnas_nand_remove,
+ .driver = {
+ .name = "oxnas_nand",
+ .of_match_table = oxnas_nand_match,
+ },
+};
+
+module_platform_driver(oxnas_nand_driver);
+
+MODULE_LICENSE("GPL");
+MODULE_AUTHOR("Neil Armstrong <narmstrong@baylibre.com>");
+MODULE_DESCRIPTION("Oxnas NAND driver");
+MODULE_ALIAS("platform:oxnas_nand");
--
2.7.0
\
 
 \ /
  Last update: 2016-10-19 16:57    [W:0.059 / U:0.040 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site