lkml.org 
[lkml]   [2016]   [Jan]   [6]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v2 4/5] ARM: at91/dt: sama5d2 Xplained: enable the adc device
Date
Enable the adc on the sama5d2 Xplained board.

Signed-off-by: Ludovic Desroches <ludovic.desroches@atmel.com>
---
arch/arm/boot/dts/at91-sama5d2_xplained.dts | 22 ++++++++++++++++++++++
1 file changed, 22 insertions(+)

diff --git a/arch/arm/boot/dts/at91-sama5d2_xplained.dts b/arch/arm/boot/dts/at91-sama5d2_xplained.dts
index 77ddff0..c3102a0 100644
--- a/arch/arm/boot/dts/at91-sama5d2_xplained.dts
+++ b/arch/arm/boot/dts/at91-sama5d2_xplained.dts
@@ -261,7 +261,29 @@
};
};

+ adc: adc@fc030000 {
+ vddana-supply = <&vdd_3v3_lp_reg>;
+ vref-supply = <&vdd_3v3_lp_reg>;
+ pinctrl-names = "default";
+ pinctrl-0 = <&pinctrl_adc_default>;
+ status = "okay";
+ };
+
pinctrl@fc038000 {
+ /*
+ * There is no real pinmux for ADC, if the pin
+ * is not requested by another peripheral then
+ * the muxing is done when channel is enabled.
+ * Requesting pins for ADC is GPIO is
+ * encouraged to prevent conflicts and to
+ * disable bias in order to be in the same
+ * state when the pin is not muxed to the adc.
+ */
+ pinctrl_adc_default: adc_default {
+ pinmux = <PIN_PD23__GPIO>;
+ bias-disable;
+ };
+
pinctrl_flx0_default: flx0_default {
pinmux = <PIN_PB28__FLEXCOM0_IO0>,
<PIN_PB29__FLEXCOM0_IO1>;
--
2.5.0


\
 
 \ /
  Last update: 2016-01-06 17:21    [W:0.362 / U:0.052 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site