lkml.org 
[lkml]   [2016]   [Jan]   [29]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH V13 02/10] dma: hidma: Add Device Tree binding
Date
Add documentation for the Qualcomm Technologies HIDMA binding.

Signed-off-by: Sinan Kaya <okaya@codeaurora.org>
Acked-by: Rob Herring <robh@kernel.org>
---
.../devicetree/bindings/dma/qcom_hidma_mgmt.txt | 92 ++++++++++++++++++++++
1 file changed, 92 insertions(+)
create mode 100644 Documentation/devicetree/bindings/dma/qcom_hidma_mgmt.txt

diff --git a/Documentation/devicetree/bindings/dma/qcom_hidma_mgmt.txt b/Documentation/devicetree/bindings/dma/qcom_hidma_mgmt.txt
new file mode 100644
index 0000000..e3677a5
--- /dev/null
+++ b/Documentation/devicetree/bindings/dma/qcom_hidma_mgmt.txt
@@ -0,0 +1,92 @@
+Qualcomm Technologies HIDMA Management interface
+
+Qualcomm Technologies HIDMA is a high speed DMA device. It only supports
+memcpy and memset capabilities. It has been designed for virtualized
+environments.
+
+Each HIDMA HW instance consists of multiple DMA channels. These channels
+share the same bandwidth. The bandwidth utilization can be parititioned
+among channels based on the priority and weight assignments.
+
+There are only two priority levels and 15 weigh assignments possible.
+
+Other parameters here determine how much of the system bus this HIDMA
+instance can use like maximum read/write request and and number of bytes to
+read/write in a single burst.
+
+Main node required properties:
+- compatible: "qcom,hidma-mgmt-1.0";
+- reg: Address range for DMA device
+- dma-channels: Number of channels supported by this DMA controller.
+- max-write-burst-bytes: Maximum write burst in bytes that HIDMA can
+ occupy the bus for in a single transaction. A memcpy requested is
+ fragmented to multiples of this amount. This parameter is used while
+ writing into destination memory. Setting this value incorrectly can
+ starve other peripherals in the system.
+- max-read-burst-bytes: Maximum read burst in bytes that HIDMA can
+ occupy the bus for in a single transaction. A memcpy request is
+ fragmented to multiples of this amount. This parameter is used while
+ reading the source memory. Setting this value incorrectly can starve
+ other peripherals in the system.
+- max-write-transactions: This value is how many times a write burst is
+ applied back to back while writing to the destination before yielding
+ the bus.
+- max-read-transactions: This value is how many times a read burst is
+ applied back to back while reading the source before yielding the bus.
+- channel-reset-timeout-cycles: Channel reset timeout in cycles for this SOC.
+ Once a reset is applied to the HW, HW starts a timer for reset operation
+ to confirm. If reset is not completed within this time, HW reports reset
+ failure.
+
+Sub-nodes:
+
+HIDMA has one or more DMA channels that are used to move data from one
+memory location to another.
+
+When the OS is not in control of the management interface (i.e. it's a guest),
+the channel nodes appear on their own, not under a management node.
+
+Required properties:
+- compatible: must contain "qcom,hidma-1.0"
+- reg: Addresses for the transfer and event channel
+- interrupts: Should contain the event interrupt
+- desc-count: Number of asynchronous requests this channel can handle
+- channel-index: The HW event channel completions will be delivered.
+- iommus: required a iommu node
+
+Example:
+
+Hypervisor OS configuration:
+
+ hidma-mgmt@f9984000 = {
+ compatible = "qcom,hidma-mgmt-1.0";
+ reg = <0xf9984000 0x15000>;
+ dma-channels = <6>;
+ max-write-burst-bytes = <1024>;
+ max-read-burst-bytes = <1024>;
+ max-write-transactions = <31>;
+ max-read-transactions = <31>;
+ channel-reset-timeout-cycles = <0x500>;
+
+ hidma_24: dma-controller@0x5c050000 {
+ compatible = "qcom,hidma-1.0";
+ reg = <0 0x5c050000 0x0 0x1000>,
+ <0 0x5c0b0000 0x0 0x1000>;
+ interrupts = <0 389 0>;
+ desc-count = <10>;
+ iommus = <&system_mmu>;
+ channel-index = <4>;
+ };
+ };
+
+Guest OS configuration:
+
+ hidma_24: dma-controller@0x5c050000 {
+ compatible = "qcom,hidma-1.0";
+ reg = <0 0x5c050000 0x0 0x1000>,
+ <0 0x5c0b0000 0x0 0x1000>;
+ interrupts = <0 389 0>;
+ desc-count = <10>;
+ channel-index = <4>;
+ iommus = <&system_mmu>;
+ };
--
1.8.2.1
\
 
 \ /
  Last update: 2016-01-30 00:01    [W:0.256 / U:0.280 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site