lkml.org 
[lkml]   [2015]   [Sep]   [3]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [GIT PULL] Ext3 removal, quota & udf fixes
On Thu, Sep 03, 2015 at 12:36:08PM -0700, Darrick J. Wong wrote:
> On Thu, Sep 03, 2015 at 07:16:19PM +0000, Richard Yao wrote:
> > On Thu, Sep 03, 2015 at 11:36:57AM -0700, Darrick J. Wong wrote:
> > > On Thu, Sep 03, 2015 at 06:22:25PM +0000, Richard Yao wrote:
> > > > What happens with this patch if /dev/$DEVICE is ext4 formatted and someone runs
> > > > `mount -t ext3 /dev/$DEVICE $MNT`?
> > > >
> > > > This should fail with the ext3 driver, but it looks like it will work fine with
> > > > CONFIG_EXT4_USE_FOR_EXT23 because ext3_fs_type maps to ext4_mount. My system is
> > > > not built with CONFIG_EXT4_USE_FOR_EXT23 (long story short: it uses a RHEL6
> > > > derived config on Linux 4.1) and I do not have time to rebuild it to verify my
> > > > suspicion, but I imagine there are others on the list that could trivially check
> > > > this.
> > >
> > > On 4.2 with CONFIG_EXT4_USE_FOR_EXT23:
> > >
> > > # mke2fs -T ext4 /dev/sda
> > > # mount /dev/sda /mnt -t ext3
> > > mount: wrong fs type, bad option, bad superblock on /dev/sda,
> > > missing codepage or helper program, or other error
> > > In some cases useful info is found in syslog - try
> > > dmesg | tail or so
> > >
> > > # lsmod|grep ext
> > > ext4 630784 0
> > > jbd2 126976 1 ext4
> > > mbcache 20480 1 ext4
> > > # dmesg
> > > <snip>
> > > [74559.632979] EXT4-fs (sda): couldn't mount as ext3 due to feature incompatibilities
> > >
> > > > Also, new kernels are typically drop-in replacements on older userlands. An edge
> > > > case that no one appears to have mentioned is the possibility of using a newer
> > > > kernel on an older system where the initramfs generator might only include ext3,
> > > > which this would break. It might not be terrible to write a small dummy ext3
> > > > module whose only purpose is to depend on ext4 and load it into the kernel on
> > > > those systems. That way initramfs software that properly grabs module
> > > > dependencies will include the ext4 module and `modprobe ext3` will do what it
> > >
> > > Well, if it goes looking for ext3.ko directly it will fail, but...
> > >
> > > # modinfo ext3
> > > filename: /lib/modules/4.2.0-mcsum/kernel/fs/ext4/ext4.ko
> > > license: GPL
> > > description: Fourth Extended Filesystem
> > > author: Remy Card, Stephen Tweedie, Andrew Morton, Andreas Dilger, Theodore Ts'o and others
> > > alias: fs-ext4
> > > alias: ext3
> > > alias: fs-ext3
> > > <snip>
> > >
> > > I don't know about RHEL initrd scripts, but Ubuntu's use some modprobe trickery
> > > which ensures that it picks up the correct ext4.ko. It does something similar
> > > to this:
> > >
> > > # modprobe --ignore-install --quiet --show-depends ext3 | sed -e 's/^insmod //g'
> > > /lib/modules/4.2.0-mcsum/kernel/fs/mbcache.ko
> > > /lib/modules/4.2.0-mcsum/kernel/fs/jbd2/jbd2.ko
> > > /lib/modules/4.2.0-mcsum/kernel/fs/ext4/ext4.ko
> > >
> > > to pick up the modules for the initramfs. Not sure what the other distros
> > > do, though.
> >
> > Unfortunately, the genkernel team was not aware of this when it wrote support
> > for including kernel modules and I suspect others writing initramfs archive
> > generators did not either.
> >
> > https://gitweb.gentoo.org/proj/genkernel.git/tree/gen_initramfs.sh#n638
> > https://gitweb.gentoo.org/proj/genkernel.git/tree/gen_moddeps.sh
> > https://gitweb.gentoo.org/proj/genkernel.git/tree/defaults/modules_load
> >
> > The way that works is that the module names are specified in a MODULES_*
> > variable and then we search for dependencies based on what is specified in
> > modules.dep. If you have an old enough version of the initramfs genreator, ext4
> > is not specified and it will not recognize the alias.
> >
> > I admit that this is likely a very rare edge case. I do not feel too strongly
> > about breaking the older initramfs software. I just wanted to make sure others
> > knew that they were.
>
> Hmmm, is there no modules.alias on Gentoo? That seems unlikely to me, but
> I haven't run it in a while. It's unfortunate that it doesn't get parsed
> as part of initrd generation.

We have it in /lib/modules/$(unamr -r), but it was not used by genkernel in 2010
and is not used yet now. That will change soon, but it is not possible to go
back in time and patch things in 2010. The idea that ext3.ko would be removed
replaced via an alias had not occurred to anyone back then.

> <shrug> I guess the initrd would break if you were trying to install a 4.3
> kernel onto a pre-2010ish Gentoo rootfs, unless that file gets updated(?)

That is correct.

> --D
>
> >
> > > > always did in terms of making ext3 file systems mountable. I suppose that we
> > > > could use aliases, but given that there is a compatibility shim for CONFIG_EXT3
> > > > to avoid surprises, a dummy module seems reasonable.
> > > >
> > > > These are the only two things that I see preventing ext4 from being a drop-in
> > > > replacement for ext3.
> > > >
> > > > That said, my only connection with ext3/ext4 is that I am one of the genkernel
> > > > developers (Gentoo's Linux initramfs/kernel genreation framework/scripts), so
> > > > my opinion might not matter much here, but I am also in favor of killing ext3 in
> > > > favor of CONFIG_EXT4_USE_FOR_EXT23.
> > >
> > > :)
> > >
> > > --D
> > >
> > > > --
> > > > To unsubscribe from this list: send the line "unsubscribe linux-ext4" in
> > > > the body of a message to majordomo@vger.kernel.org
> > > > More majordomo info at http://vger.kernel.org/majordomo-info.html
> > --
> > To unsubscribe from this list: send the line "unsubscribe linux-ext4" in
> > the body of a message to majordomo@vger.kernel.org
> > More majordomo info at http://vger.kernel.org/majordomo-info.html


\
 
 \ /
  Last update: 2015-09-04 00:41    [W:0.077 / U:51.448 seconds]
©2003-2017 Jasper Spaans. hosted at Digital OceanAdvertise on this site