lkml.org 
[lkml]   [2015]   [Sep]   [15]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Subject[PATCH v3 0/2] Add Cygnus PCIe Serdes/PHY support
Date
This patch series adds support for the Cygnus PCIe PHY

This patch series is based on Linux v4.3-rc1 and is avaliable in:
https://github.com/Broadcom/cygnus-linux/tree/cygnus-pcie-phy-v3

Changes from v2:
- Dropped MDC/MDIO bus driver since it's not needed to enable/disable the
analog-front-end of the PCIe Serdes on Cygnus
- Optimized delay waiting for PCIe analog-front-end to be fully enabled
- Reduce the #phy-cell to 1 since now the MDIO PHY ID is not required

Changes from v1:
- Move the MDC/MDIO bus driver from drivers/phy/* to drivers/bus/*
- Make the PCIe PHY device node child node of the MDIO bus
- Change the PCIe PHY driver to tristate so it can be compiled as a module
- Other minor changes

Ray Jui (2):
dt-bindings: Add Broadcom Cygnus PCIe PHY binding
phy: cygnus: pcie: Add Cygnus PCIe PHY support

.../bindings/phy/brcm,cygnus-pcie-phy.txt | 30 ++++
drivers/phy/Kconfig | 9 +
drivers/phy/Makefile | 1 +
drivers/phy/phy-bcm-cygnus-pcie.c | 198 +++++++++++++++++++++
4 files changed, 238 insertions(+)
create mode 100644 Documentation/devicetree/bindings/phy/brcm,cygnus-pcie-phy.txt
create mode 100644 drivers/phy/phy-bcm-cygnus-pcie.c

--
1.9.1



\
 
 \ /
  Last update: 2015-09-15 20:21    [W:0.285 / U:0.044 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site