lkml.org 
[lkml]   [2015]   [Sep]   [15]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v2 5/9] phy: ti-pipe3: use ti_pipe3_power_off to power off the PHY during probe
Date
No functional change. Previously omap_control_phy_power() was used to power
off the PHY during probe. But once PIPE3 driver is adapted to use syscon,
omap_control_phy_power() cannot be used. Hence used ti_pipe3_power_off
to power off the PHY.

Signed-off-by: Kishon Vijay Abraham I <kishon@ti.com>
Acked-by: Roger Quadros <rogerq@ti.com>
---
drivers/phy/phy-ti-pipe3.c | 5 +++--
1 file changed, 3 insertions(+), 2 deletions(-)

diff --git a/drivers/phy/phy-ti-pipe3.c b/drivers/phy/phy-ti-pipe3.c
index 1991efd..0ce4194 100644
--- a/drivers/phy/phy-ti-pipe3.c
+++ b/drivers/phy/phy-ti-pipe3.c
@@ -475,8 +475,6 @@ static int ti_pipe3_probe(struct platform_device *pdev)
if (ret)
return ret;

- omap_control_phy_power(phy->control_dev, 0);
-
platform_set_drvdata(pdev, phy);
pm_runtime_enable(dev);

@@ -495,6 +493,9 @@ static int ti_pipe3_probe(struct platform_device *pdev)
return PTR_ERR(generic_phy);

phy_set_drvdata(generic_phy, phy);
+
+ ti_pipe3_power_off(generic_phy);
+
phy_provider = devm_of_phy_provider_register(dev, of_phy_simple_xlate);
if (IS_ERR(phy_provider))
return PTR_ERR(phy_provider);
--
1.7.9.5


\
 
 \ /
  Last update: 2015-09-15 15:21    [W:0.057 / U:0.120 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site