lkml.org 
[lkml]   [2015]   [Sep]   [14]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH v3 1/5] Documentation: add DT bindings for ARM SCPI sensors
> >> +Sensor bindings for the sensors based on SCPI Message Protocol
> >> +--------------------------------------------------------------
> >> +SCPI provides an API to access the various sensors on the SoC.
> >> +
> >> +Required properties:
> >> +- compatible : should be "arm,scpi-sensors".
> >> +- #thermal-sensor-cells: should be set to 1. This property follows the
> >> + thermal device tree bindings[2].
> >
> > You need to specify what the valid values for this cell are.
>
> The enumeration depends on the number of sensors exported by SCP
> firmware - which is platform dependent. I could add add something like
> if you think that is helpful -
>
> "Valid cell value is a number between 0..n-1, where n is the number
> of sensors exported by SCP firmware."

Can the FW identifer space have holes? Or are they always contiguous?

If this is the same as the raw FW identifer value, specify that.
Otherwise, you need to specify the mapping.

There needs to be enough information for a dts author to figure out
which values to place in the DT.

Thanks,
Mark.


\
 
 \ /
  Last update: 2015-09-14 16:01    [W:0.086 / U:0.180 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site