lkml.org 
[lkml]   [2015]   [Sep]   [10]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
SubjectRe: [PATCHv2 2/3] devicetree: Add new ANX7814 SlimPort transmitter binding.
From
Hi Rob,

2015-09-09 2:40 GMT+02:00 Rob Herring <robh@kernel.org>:
> On 09/08/2015 02:25 AM, Enric Balletbo i Serra wrote:
>> The ANX7814 is an ultra-low power Full-HD (1080p60) SlimPort transmitter
>> designed for portable devices.
>>
>> You can add support to your board with current binding.
>>
>> Example:
>>
>> anx7814: anx7814@38 {
>> compatible = "analogix,anx7814";
>> reg = <0x38>;
>> pd-gpios = <&gpio0 1 GPIO_ACTIVE_HIGH>;
>> reset-gpios = <&gpio0 2 GPIO_ACTIVE_HIGH>;
>> };
>>
>> Signed-off-by: Enric Balletbo i Serra <enric.balletbo@collabora.com>
>> ---
>> .../devicetree/bindings/video/anx7814.txt | 22 ++++++++++++++++++++++
>> 1 file changed, 22 insertions(+)
>> create mode 100644 Documentation/devicetree/bindings/video/anx7814.txt
>>
>> diff --git a/Documentation/devicetree/bindings/video/anx7814.txt b/Documentation/devicetree/bindings/video/anx7814.txt
>> new file mode 100644
>> index 0000000..a8cc746
>> --- /dev/null
>> +++ b/Documentation/devicetree/bindings/video/anx7814.txt
>> @@ -0,0 +1,22 @@
>> +Analogix ANX7814 SlimPort (Full-HD Transmitter)
>> +-----------------------------------------------
>> +
>> +The ANX7814 is an ultra-low power Full-HD (1080p60) SlimPort transmitter
>> +designed for portable devices.
>> +
>> +Required properties:
>> +
>> + - compatible : "analogix,anx7814"
>> + - reg : I2C address of the device
>> + - pd-gpios : Which GPIO to use for power down
>> + - reset-gpios : Which GPIO to use for reset
>> +
>> +Example:
>> +
>> + anx7814: anx7814@38 {
>> + compatible = "analogix,anx7814";
>> + reg = <0x38>;
>> + pd-gpios = <&gpio0 1 GPIO_ACTIVE_HIGH>;
>> + reset-gpios = <&gpio0 2 GPIO_ACTIVE_HIGH>;
>
> No ports needed for describing data connections?
>

IMHO I'm not sure if this is applicable here, in this case the bridge
is transparent so it's not required another device node. For example,
I've an evaluation board, whre I connect in one side an HDMI input
signal an in the other side a DP monitor, the driver only configures
the chip and waits for different events (cable plug, cable unplug, etc
..)

Cheers,
Enric

> Rob
>
>> + };
>> +
>>
>


\
 
 \ /
  Last update: 2015-09-10 16:21    [W:0.057 / U:0.256 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site