lkml.org 
[lkml]   [2015]   [Sep]   [10]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH] staging: slicoss: remove unused variables
On Wed, Sep 09, 2015 at 11:31:37AM -0700, Greg Kroah-Hartman wrote:
> On Fri, Sep 04, 2015 at 06:53:18PM +0530, Sudip Mukherjee wrote:
> > These variables were only assigned some values but they were never used.
> >
> > Signed-off-by: Sudip Mukherjee <sudip@vectorindia.org>
> > ---
> > drivers/staging/slicoss/slicoss.c | 27 ++++++---------------------
> > 1 file changed, 6 insertions(+), 21 deletions(-)
> >
> > diff --git a/drivers/staging/slicoss/slicoss.c b/drivers/staging/slicoss/slicoss.c
> > index 8585970..1536ca0 100644
> > --- a/drivers/staging/slicoss/slicoss.c
> > +++ b/drivers/staging/slicoss/slicoss.c
<snip>
> > @@ -1730,15 +1727,13 @@ static void slic_link_event_handler(struct adapter *adapter)
> > pshmem = (struct slic_shmem *)(unsigned long)adapter->phys_shmem;
> >
> > #if BITS_PER_LONG == 64
> > - status = slic_upr_request(adapter,
> > - SLIC_UPR_RLSR,
> > - SLIC_GET_ADDR_LOW(&pshmem->linkstatus),
> > - SLIC_GET_ADDR_HIGH(&pshmem->linkstatus),
> > - 0, 0);
> > + slic_upr_request(adapter, SLIC_UPR_RLSR,
> > + SLIC_GET_ADDR_LOW(&pshmem->linkstatus),
> > + SLIC_GET_ADDR_HIGH(&pshmem->linkstatus), 0, 0);
> > #else
> > - status = slic_upr_request(adapter, SLIC_UPR_RLSR,
> > - (u32) &pshmem->linkstatus, /* no 4GB wrap guaranteed */
> > - 0, 0, 0);
> > + slic_upr_request(adapter, SLIC_UPR_RLSR,
> > + (u32)&pshmem->linkstatus, /* no 4GB wrap guaranteed */
> > + 0, 0, 0);
>
> Shouldn't we do something with status instead of just ignoring it?
I can think of 3 possibilities.
1) Ignore it as this is writing READ_LINK_STATUS command to the device
asynchronously, and then writing UP configuration command. So if status
is error here then the device will not be UP.

2) loop here with a delay until the call succeeds. (will be a very bad
design, but there are some codes doing that). But this functions is also
called from an ISR so we should not be doing that.

3) return the error code and do the error handling properly by clearing
and releasing all resources acquired by the function which called it.

Which one will you suggest? I am sure you will say : 3. :)

regards
sudip


\
 
 \ /
  Last update: 2015-09-10 15:41    [W:0.067 / U:0.676 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site