lkml.org 
[lkml]   [2015]   [Jul]   [28]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [linux-sunxi] [RFC] ARM: dts: sunxi: Add regulators and board-specific operating points for LeMaker BananaPi
On Tue, Jul 28, 2015 at 11:02:16AM +0200, Timo Sigurdsson wrote:
> Hi,
>
> Chen-Yu Tsai schrieb am 27.07.2015 15:14:
> >> ChenYu (in the CC), since you did most of the original work here, do
> >> you know why we have an op at 0.9 volt, but none of our boards allow the
> >> voltage to go that low in the regulator settings ?
> >
> > I'm on vacation now, so apologies for the bad formatting.
> >
> > The OPPs are from a common subset
> > of the settings from the fex files available
> > at the time. Some fex files actually set
> > min and max voltage thus eliminating
> > the highest and lowest OPPs.
> >
> > At least that is how Maxime and I
> > interpreted them.
>
> IMHO for a common maximum opp that's a good approach. But for the lowest
> frequency setting, it would seem more logical to me, to raise the voltage
> to a point where all boards will run fine with them, unless those boards
> cannot handle the frequency regardless of the higher voltage.

Agreed.

Maxime

--
Maxime Ripard, Free Electrons
Embedded Linux, Kernel and Android engineering
http://free-electrons.com
[unhandled content-type:application/pgp-signature]
\
 
 \ /
  Last update: 2015-07-28 15:21    [W:0.070 / U:1.500 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site