lkml.org 
[lkml]   [2015]   [Jun]   [27]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH v7] dma: Add Xilinx AXI Direct Memory Access Engine driver support
On Wed, Jun 24, 2015 at 05:12:13PM +0000, Appana Durga Kedareswara Rao wrote:
> > where is the hardware addr programmed? I can see you are using sg list
> > passed for porgramming one side of a transfer where is other side
> > programmed?
>
> The actual programming happens in the start_transfer(I mean in issue_pending) API
> There are two modes
>
> All the h/w addresses are configured in the start_transfer API.
>
> In simple transfer Mode the below write triggers the transfer
> dma_ctrl_write(chan, XILINX_DMA_REG_BTT,
> hw->control & XILINX_DMA_MAX_TRANS_LEN);
>
> In SG Mode the below write triggers the transfer.
> dma_ctrl_write(chan, XILINX_DMA_REG_TAILDESC, tail->phys);
>
> There are two Channels MM2S (Memory to device) and S2MM (Device to Memory) channel.
> --> In MM2S case we need to configure the SOF (Start of frame) for the first BD and we need to set EOF(end of frame) for the last BD
> --> For S2MM case no need to configure SOF and EOF. Once we got the IOC interrupt will call mark the cookie as complete and will
> Call the user callback. There users checks for the data.
>
> Please let me know if you are not clear.
No sorry am not...

I asked how the device address in configured. For both MM2S S2MM you are
using sg for memory address, where are you getting device adress, are you
assuming/hardcoding or getting somehow, if so how?

> > no dma_slave_config handler?
> No need of this callback earlier in the dma_slave_config we are doing terminate_all
> Now we have a separate API for that so no need to have this call back.

The question was on parameters

--
~Vinod


\
 
 \ /
  Last update: 2015-06-27 17:01    [W:0.289 / U:0.012 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site