lkml.org 
[lkml]   [2015]   [Jun]   [1]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH 2/2] Bluetooth: btusb: Add reset_resume function
Date

Some USB hubs may lose power across suspend/resume.
Add a reset_resume callback to properly reset those bluetoot devices.

Signed-off-by: Laura Abbott <labbott@fedoraproject.org>
---
Now the setup function is called again with the HCI_RESET_RESUME
flag set. The various functions could then use that RESET_RESUME
flag to determine if loading the firmware is appropriate or not.
---
drivers/bluetooth/btusb.c | 16 ++++++++++++++++
1 file changed, 16 insertions(+)

diff --git a/drivers/bluetooth/btusb.c b/drivers/bluetooth/btusb.c
index 3c10d4d..34884cf 100644
--- a/drivers/bluetooth/btusb.c
+++ b/drivers/bluetooth/btusb.c
@@ -3382,6 +3382,21 @@ done:

return err;
}
+
+static int btusb_reset_resume(struct usb_interface *intf)
+{
+ struct btusb_data *data = usb_get_intfdata(intf);
+ struct hci_dev *hdev = data->hdev;
+ int ret;
+
+ BT_DBG("intf %p", intf);
+
+ ret = btusb_resume(intf);
+ if (ret)
+ return ret;
+
+ return hci_reset_resume_dev(hdev);
+}
#endif

static struct usb_driver btusb_driver = {
@@ -3391,6 +3406,7 @@ static struct usb_driver btusb_driver = {
#ifdef CONFIG_PM
.suspend = btusb_suspend,
.resume = btusb_resume,
+ .reset_resume = btusb_reset_resume,
#endif
.id_table = btusb_table,
.supports_autosuspend = 1,
--
2.4.1


\
 
 \ /
  Last update: 2015-06-02 03:41    [W:0.187 / U:0.472 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site