lkml.org 
[lkml]   [2015]   [May]   [5]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [RFC PATCH 14/14] ASoC: qcom: document apq8016 machine driver bindings


On 03/05/15 01:03, Kenneth Westfield wrote:
> On Thu, Apr 30, 2015 at 06:18:26PM +0100, Srinivas Kandagatla wrote:
>> This patch adds bindings for apq8016 machine driver.
>> On APQ8016 4 MI2S can be configured to different sinks like internal
>> codec/external codec, this connection is controlled via 2 iomux
>> registers.
>>
>> +sound: sound {
>> + compatible = "qcom,apq8016-sndcard";
>> + reg = <0x07702000 0x4>, <0x07702004 0x4>;
>> + reg-names = "mic-iomux", "spkr-iomux";
>> + qcom,model = "DB410c";
>> +
>> + /* I2S - Internal codec */
>> + internal-dai-link@0 {
>> + cpu { /* PRIMARY */
>> + sound-dai = <&lpass MI2S_PRIMARY>;
>> + };
>> + codec {
>> + sound-dai = <&wcd_codec 0>;
>> + };
>> + };
>> +
>> + /* External Primary or External Secondary -ADV7533 HDMI */
>> + external-dai-link@0 {
>> + external;
>> + cpu { /* QUAT */
>> + sound-dai = <&lpass MI2S_QUATERNARY>;
>> + };
>> + codec {
>> + sound-dai = <&adv_bridge 0>;
>> + };
>> + };
>> +};
>
> OK, although I will need to double-check this with the spec, it seems
> (from the patches) that there are 4 I2S ports, 2 of which are being
> used. Usually, multi-channel audio is sent to the primary dai (which
> is MI2S), which then gets sent to the other ports by HW. If that holds
> true for this SOC, then the external cpu dai should be labelled I2S,
> not MI2S. If not, then both should be labelled as I2S (and the DAI
> channel constraints should be reduced to 1-2).
>
I have got very limited access to documentation, which obviously does
not have any info related to channel capabilities. I was thinking that
all the playback ports support multi-channel. I might be wrong though.

> Looking at patch 12, the internal DAI is labelled Headset and the
> external DAI is labelled HDMI.
This naming is very specific to the SBC board.

I will check the spec to see if the QUAT
> I2S port can handle multi-channel.
External HDMI bridge on the other side only supports 2-channels, but if
you can re-check on the channel capabilities would be good.

--srini

>


\
 
 \ /
  Last update: 2015-05-05 09:21    [W:0.107 / U:1.512 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site