lkml.org 
[lkml]   [2015]   [Feb]   [20]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH] ARM: dts: OMAP3-N900: Fix offset for smc91x ethernet
* Pali Rohár <pali.rohar@gmail.com> [150220 01:56]:
> On Friday 20 February 2015 10:24:35 Arnd Bergmann wrote:
> > On Thursday 19 February 2015 17:49:50 Pali Rohár wrote:
> > > Offset for smc91x must be zero otherwise smc91x linux kernel
> > > driver does not detect smc91x ethernet hardware in qemu
> > > N900 machine.
> > >
> > > Signed-off-by: Pali Rohár <pali.rohar@gmail.com>
> >
> > Is that the same offset on real hardware, or could this be a
> > mistake in the qemu model?
> >
> > Arnd
>
> In original Nokia 2.6.28 kernel is offset also set to 0, see:
>
> https://gitorious.org/linux-n900/linux-n900/source/629fc5ab00cafb31272c478efa2c2b35fabd4c70:arch/arm/mach-omap2/board-rx51-peripherals.c#L42
>
> https://gitorious.org/linux-n900/linux-n900/source/629fc5ab00cafb31272c478efa2c2b35fabd4c70:arch/arm/mach-omap2/board-rx51-peripherals.c#L274
>
> Tony already tested offset 0 on real HW and wrote that it is
> working too, just show some warning. But qemu with offset 0x300
> does not work.

Yes it works with offset 0, except the smc91x warns about not
using the default offset 0x300 based on the EEPROM. As only
three address lines seem to be connected, we can use offset
0 just fine, and update the EEPROM configuration as needed.

Regards,

Tony


\
 
 \ /
  Last update: 2015-02-20 17:01    [W:0.062 / U:0.932 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site