lkml.org 
[lkml]   [2015]   [Dec]   [2]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
SubjectRe: Skylake (XPS 13 9350) TSC is way off
From
On Wed, Dec 2, 2015 at 3:25 PM, Andy Lutomirski <luto@kernel.org> wrote:
> In case it's at all useful, adjtimex -p says:
>
> mode: 0
> offset: 0
> frequency: 135641
> maxerror: 37498
> esterror: 1532
> status: 8192
> time_constant: 2
> precision: 1
> tolerance: 32768000
> tick: 10000
> raw time: 1449098317s 671243180us = 1449098317.671243180
>
> this suggests a rather small correction, so I really have no idea what
> "Adjusting tsc more than 11% (8039115 vs 7759462)" means.
>
> John, you wrote this code. What does the error message mean?

Basally the internal correction adjustments are getting pulled further
then it is supposed to (its concerning since in some cases we push the
clocksource mult value to be quite large, and so making a large
adjustment could possibly cause an overflow).

Awhile back I had intended to cap the max adjustment, but out of
caution I put in a warning instead to see how often this might occur.

I've seen it reported sometimes while folks were running trinity or
under a VM (suggesting that due to system delays timekeeping
management may have been delayed and the internal time error had grown
quite far, so the internal correction was being somewhat aggressive).
Though more recently (3.17 era) we've changed the internal adjustment
code to try to be more conservative to avoid over-steering w/ NOHZ, so
I'd expect fewer of these.

On a hunch, are you running chrony instead of ntpd?

thanks
-john


\
 
 \ /
  Last update: 2015-12-03 01:01    [W:0.065 / U:0.532 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site