lkml.org 
[lkml]   [2015]   [Nov]   [10]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Date
SubjectRe: [PATCH v7 1/4] Documentation: dt-bindings: Describe SROMc configuration
On Fri, Nov 6, 2015 at 4:03 AM, Pavel Fedin <p.fedin@samsung.com> wrote:
> Add documentation for new subnode properties, allowing bank configuration.
> Based on u-boot implementation, but heavily reworked.
>
> Also, fix size of SROMc mapping in the example.
>
> Signed-off-by: Pavel Fedin <p.fedin@samsung.com>
> Reviewed-by: Krzysztof Kozlowski <k.kozlowski@samsung.com>
> ---
> .../bindings/arm/samsung/exynos-srom.txt | 71 +++++++++++++++++++++-
> 1 file changed, 69 insertions(+), 2 deletions(-)
>
> diff --git a/Documentation/devicetree/bindings/arm/samsung/exynos-srom.txt b/Documentation/devicetree/bindings/arm/samsung/exynos-srom.txt
> index 33886d5..3ff2950 100644
> --- a/Documentation/devicetree/bindings/arm/samsung/exynos-srom.txt
> +++ b/Documentation/devicetree/bindings/arm/samsung/exynos-srom.txt
> @@ -5,8 +5,75 @@ Required properties:
>
> - reg: offset and length of the register set
>
> -Example:
> +Optional properties:
> +The SROM controller can be used to attach external peripherals. In this case
> +extra properties, describing the bus behind it, should be specified as below:
> +
> +- #address-cells: Must be set to 2 to allow memory address translation

2 is for CS# and offset.

> +
> +- #size-cells: Must be set to 1 to allow CS address passing

size is the size, not the address.

> +
> +- ranges: Must be set up to reflect the memory layout with four integer values
> + per bank:
> + <bank-number> 0 <physical address of bank> <size>

s/physical/parent/

You could have another level of translation above for the parent.

> +
> +Sub-nodes:
> +The actual device nodes should be added as subnodes to the SROMc node. These
> +subnodes, except regular device specification, should contain the following
> +properties, describing configuration of the relevant SROM bank:
> +
> +Required properties:
> +- reg: bank number, base address (relative to start of the bank) and size of
> + the memory mapped for the device. Note that base address will be
> + typically 0 as this is the start of the bank.
> +
> +- samsung,srom-timing : array of 6 integers, specifying bank timings in the
> + following order: Tacp, Tcah, Tcoh, Tacc, Tcos, Tacs.
> + Each value is specified in cycles and has the following
> + meaning and valid range:
> + Tacp : Page mode access cycle at Page mode (0 - 15)
> + Tcah : Address holding time after CSn (0 - 15)
> + Tcoh : Chip selection hold on OEn (0 - 15)
> + Tacc : Access cycle (0 - 31, the actual time is N + 1)
> + Tcos : Chip selection set-up before OEn (0 - 15)
> + Tacs : Address set-up before CSn (0 - 15)

This is not easily extended. Perhaps a property per value instead.

> +
> +Optional properties:
> +- reg-io-width : data width in bytes (1 or 2). If omitted, default of 1 is used.
> +
> +- samsung,srom-page-mode : page mode configuration for the bank:
> + 0 - normal (one data)
> + 1 - four data
> + If omitted, default of 0 is used.
> +
> +Example: basic definition, no banks are configured
> + sromc@12570000 {
> + compatible = "samsung,exynos-srom";
> + reg = <0x12570000 0x14>;
> + };
> +
> +Example: SROMc with SMSC911x ethernet chip on bank 3
> sromc@12570000 {
> + #address-cells = <2>;
> + #size-cells = <1>;
> + ranges = <0 0 0x04000000 0x20000 // Bank0
> + 1 0 0x05000000 0x20000 // Bank1
> + 2 0 0x06000000 0x20000 // Bank2
> + 3 0 0x07000000 0x20000>; // Bank3
> +
> compatible = "samsung,exynos-srom";
> - reg = <0x12570000 0x10>;
> + reg = <0x12570000 0x14>;
> +
> + ethernet@3 {
> + compatible = "smsc,lan9115";
> + reg = <3 0 0x10000>; // Bank 3, offset = 0
> + phy-mode = "mii";
> + interrupt-parent = <&gpx0>;
> + interrupts = <5 8>;
> + reg-io-width = <2>;
> + smsc,irq-push-pull;
> + smsc,force-internal-phy;
> +
> + samsung,srom-config = <1 9 12 1 9 1 1>;

This doesn't match the doc.

> + };
> };
> --
> 2.4.4
>


\
 
 \ /
  Last update: 2015-11-10 15:41    [W:0.116 / U:0.296 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site