lkml.org 
[lkml]   [2015]   [Nov]   [1]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v3 7/7] spi: imx: defer spi initialization, if DMA engine is pending
Date
From: Anton Bondarenko <anton_bondarenko@mentor.com>

If SPI device supports DMA mode, but DMA controller is not yet
available due to e.g. a delay in the corresponding kernel module
initialization, retry to initialize SPI driver later on instead of
falling back into PIO only mode.

Signed-off-by: Vladimir Zapolskiy <vladimir_zapolskiy@mentor.com>
Signed-off-by: Anton Bondarenko <anton_bondarenko@mentor.com>
---
drivers/spi/spi-imx.c | 12 +++++++++---
1 file changed, 9 insertions(+), 3 deletions(-)

diff --git a/drivers/spi/spi-imx.c b/drivers/spi/spi-imx.c
index 6035ddd..d2ea731 100644
--- a/drivers/spi/spi-imx.c
+++ b/drivers/spi/spi-imx.c
@@ -1354,9 +1354,15 @@ static int spi_imx_probe(struct platform_device *pdev)
* Only validated on i.mx6 now, can remove the constrain if validated on
* other chips.
*/
- if (is_imx51_ecspi(spi_imx) &&
- spi_imx_sdma_init(&pdev->dev, spi_imx, master))
- dev_err(&pdev->dev, "dma setup error,use pio instead\n");
+ if (is_imx51_ecspi(spi_imx)) {
+ ret = spi_imx_sdma_init(&pdev->dev, spi_imx, master);
+ if (ret == -EPROBE_DEFER)
+ goto out_clk_put;
+
+ if (ret < 0)
+ dev_err(&pdev->dev, "dma setup error %d, use pio\n",
+ ret);
+ }

spi_imx->devtype_data->reset(spi_imx);

--
2.6.2


\
 
 \ /
  Last update: 2015-11-01 16:01    [W:1.472 / U:0.012 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site