lkml.org 
[lkml]   [2015]   [Oct]   [9]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH RFC V2 3/3] Input: goodix - update dt bindings documentation (axis swapping/inversion)
Date
The goodix touchscreen driver has gained support for the
optional touchscreen-inverted-x, touchscreen-inverted-y
and touchscreen-swapped-x-y properties as described in
Documentation/devicetree/bindings/input/touchscreen/touchscreen.txt.

Document these properties in the goodix bindings description.

Signed-off-by: Karsten Merker <merker@debian.org>
---
Documentation/devicetree/bindings/input/touchscreen/goodix.txt | 6 ++++++
1 file changed, 6 insertions(+)

diff --git a/Documentation/devicetree/bindings/input/touchscreen/goodix.txt b/Documentation/devicetree/bindings/input/touchscreen/goodix.txt
index 4db3393..4ecd0e1 100644
--- a/Documentation/devicetree/bindings/input/touchscreen/goodix.txt
+++ b/Documentation/devicetree/bindings/input/touchscreen/goodix.txt
@@ -14,6 +14,7 @@ Required properties:
- interrupts : Interrupt to which the chip is connected
- irq-gpio : GPIO pin used for IRQ
- reset-gpio : GPIO pin used for reset
+
Optional properties:

- esd-recovery-timeout-ms : ESD poll time (in milli seconds) for the driver to
@@ -21,6 +22,11 @@ Optional properties:
device. ESD is disabled if this property is not set
or is set to 0.

+ - touchscreen-inverted-x : X axis is inverted (boolean)
+ - touchscreen-inverted-y : Y axis is inverted (boolean)
+ - touchscreen-swapped-x-y : X and Y axis are swapped (boolean)
+ (swapping is done after inverting the axis)
+
Example:

i2c@00000000 {
--
2.1.4


\
 
 \ /
  Last update: 2015-10-09 20:21    [W:0.085 / U:0.680 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site