lkml.org 
[lkml]   [2015]   [Oct]   [26]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
SubjectRE: [PATCH 05/11] dt-binding: Add ngpios property to GPIO controller node
Date


> -----Original Message-----
> From: Ray Jui [mailto:rjui@broadcom.com]
> Sent: 23 October 2015 21:38
> To: Laurent Pinchart; Rob Herring
> Cc: Pramod Kumar; Pawel Moll; Mark Rutland; Ian Campbell; Kumar Gala; Scott
> Branden; Russell King; Linus Walleij; linux-gpio@vger.kernel.org; bcm-kernel-
> feedback-list; Jason Uy; Masahiro Yamada; Thomas Gleixner;
> devicetree@vger.kernel.org; linux-arm-kernel@lists.infradead.org; linux-
> kernel@vger.kernel.org; Jonas Gorski
> Subject: Re: [PATCH 05/11] dt-binding: Add ngpios property to GPIO controller
> node
>
>
>
> On 10/23/2015 6:02 AM, Laurent Pinchart wrote:
> > Hi Rob,
> >
> > On Friday 23 October 2015 06:51:28 Rob Herring wrote:
> >> On Fri, Oct 23, 2015 at 4:08 AM, Laurent Pinchart wrote:
> >>> On Thursday 22 October 2015 18:41:05 Rob Herring wrote:
> >>>> On Thu, Oct 22, 2015 at 1:52 PM, Ray Jui wrote:
> >>>>> On 10/22/2015 11:43 AM, Rob Herring wrote:
> >>>>>> On Mon, Oct 19, 2015 at 12:43 AM, Pramod Kumar wrote:
> >>>>>>> Add ngpios property to the gpio controller's DT node so that
> >>>>>>> controller driver extracts total number of gpio lines present in
> >>>>>>> controller from DT and removes dependency on driver.
> >>>>>>>
> >>>>>>> Signed-off-by: Pramod Kumar <pramodku@broadcom.com>
> >>>>>>> Reviewed-by: Ray Jui <rjui@broadcom.com>
> >>>>>>> Reviewed-by: Scott Branden <sbranden@broadcom.com>
> >>>>>>> ---
> >>>>>>>
> >>>>>>> Documentation/devicetree/bindings/pinctrl/brcm,cygnus-gpio.txt | 5
> >>>>>>> +++
> >>>>>>> 1 file changed, 5 insertions(+)
> >>>>>>>
> >>>>>>> diff --git
> >>>>>>> a/Documentation/devicetree/bindings/pinctrl/brcm,cygnus-gpio.txt
> >>>>>>> b/Documentation/devicetree/bindings/pinctrl/brcm,cygnus-gpio.txt
> >>>>>>> index f92b833..655a8d7 100644
> >>>>>>> ---
> >>>>>>> a/Documentation/devicetree/bindings/pinctrl/brcm,cygnus-gpio.txt
> >>>>>>> +++ b/Documentation/devicetree/bindings/pinctrl/brcm,cygnus-gpio
> >>>>>>> +++ .txt
> >>>>>>>
> >>>>>>> @@ -10,6 +10,9 @@ Required properties:
> >>>>>>> Define the base and range of the I/O address space that
> >>>>>>> contains
> >>>>>>>
> >>>>>>> the Cygnus
> >>>>>>>
> >>>>>>> GPIO/PINCONF controller registers
> >>>>>>>
> >>>>>>> +- ngpios:
> >>>>>> + Total number of GPIOs the controller provides
> >>>>>>
> >>>>>> This must be optional for compatibility and the driver needs to
> >>>>>> handle it not present.
> >>>>>
> >>>>> You meant to be compatible with existing Cygnus devices, correct?
> >>>>>
> >>>>> Just to clarify, here you suggest we still leave the existing hard
> >>>>> coded ngpios in the driver, in order to be compatible with all
> >>>>> existing Cygnus devices (while the Cygnus device tree changes to
> >>>>> use ngpio is still being merged and through different maintainer),
> >>>>> and have all new iProc SoCs switch to use ngpios from device tree, right?
> >>>>
> >>>> Yes, an existing dtb should continue to work with a new kernel. You
> >>>> can add the DT property to the older devices too and then
> >>>> eventually remove the hard coded values some time in the future.
> >>>> That could be immediately (don't care about compatibility at all),
> >>>> a couple of kernel cycles, never... It all depends on users of the
> >>>> impacted platforms.
> >>>
> >>> But shouldn't the property still be documented as required to ensure
> >>> that new DTs always include it ?
> >>
> >> Good point. If the intent is to eventually remove it from the driver,
> >> then yes. We probably need "required for new designs" as a category
> >> or maybe "recommended"? The wording is not so important here, but I'm
> >> thinking about as we try to standardize the naming.
> >
> > Required for new designs sounds better than recommended. Or maybe
> > something like "Required (optional for backward compatibility)".
> >
>
> Yes, it should be phrased as "required for new designs" because all new iProc
> SoCs using this GPIO driver need to have this in DT.
>
> Thanks,
>
> Ray

Thanks for providing feedback. I'll make sure to use this property under phrase " required for new designs " in next patch set.

Regards,
Pramod


\
 
 \ /
  Last update: 2015-10-26 18:21    [W:0.125 / U:0.496 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site