lkml.org 
[lkml]   [2015]   [Oct]   [26]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
SubjectRe: [PATCH v3 13/15] scsi: ufs: add missing memory barriers
From
2015-10-25 23:40 GMT+09:00  <ygardi@codeaurora.org>:
>> 2015-09-02 19:13 GMT+09:00 Yaniv Gardi <ygardi@codeaurora.org>:
>>> Performing several writes to UFS host controller registers has
>>> no gurrantee of ordering, so we must make sure register writes
>>> to setup request list base address etc. are performed before the
>>> run/stop register is enabled.
>>> In addition, when setting up a task request, we must make sure
>>> the updating of descriptors takes places before ringing the
>>> doorbell, similarly to setting up a transfer request.
>>>
>>> Signed-off-by: Gilad Broner <gbroner@codeaurora.org>
>>> Signed-off-by: Yaniv Gardi <ygardi@codeaurora.org>
>>>
>>> ---
>>> drivers/scsi/ufs/ufshcd.c | 21 +++++++++++++++------
>>> 1 file changed, 15 insertions(+), 6 deletions(-)
>>>
>>> diff --git a/drivers/scsi/ufs/ufshcd.c b/drivers/scsi/ufs/ufshcd.c
>>> index fc2a52d..298511a 100644
>>> --- a/drivers/scsi/ufs/ufshcd.c
>>> +++ b/drivers/scsi/ufs/ufshcd.c
>>> @@ -401,11 +401,9 @@ static inline int ufshcd_get_lists_status(u32 reg)
>>> * 1 UTRLRDY
>>> * 2 UTMRLRDY
>>> * 3 UCRDY
>>> - * 4 HEI
>>> - * 5 DEI
>>> - * 6-7 reserved
>>> + * 4-7 reserved
>>> */
>>> - return (((reg) & (0xFF)) >> 1) ^ (0x07);
>>> + return ((reg & 0xFF) >> 1) ^ 0x07;
>>> }
>>>
>>> /**
>>> @@ -2726,7 +2724,7 @@ out:
>>> * To bring UFS host controller to operational state,
>>> * 1. Enable required interrupts
>>> * 2. Configure interrupt aggregation
>>> - * 3. Program UTRL and UTMRL base addres
>>> + * 3. Program UTRL and UTMRL base address
>>> * 4. Configure run-stop-registers
>>> *
>>> * Returns 0 on success, non-zero value on failure
>>> @@ -2756,8 +2754,13 @@ static int ufshcd_make_hba_operational(struct
>>> ufs_hba *hba)
>>> REG_UTP_TASK_REQ_LIST_BASE_H);
>>>
>>> /*
>>> + * Make sure base address and interrupt setup are updated before
>>> + * enabling the run/stop registers below.
>>> + */
>>> + wmb();
>>> +
>>> + /*
>>> * UCRDY, UTMRLDY and UTRLRDY bits must be 1
>>> - * DEI, HEI bits must be 0
>>> */
>>> reg = ufshcd_readl(hba, REG_CONTROLLER_STATUS);
>>> if (!(ufshcd_get_lists_status(reg))) {
>>> @@ -3920,7 +3923,13 @@ static int ufshcd_issue_tm_cmd(struct ufs_hba
>>> *hba, int lun_id, int task_id,
>>>
>>> /* send command to the controller */
>>> __set_bit(free_slot, &hba->outstanding_tasks);
>>> +
>>> + /* Make sure descriptors are ready before ringing the task
>>> doorbell */
>>> + wmb();
>>> +
>>> ufshcd_writel(hba, 1 << free_slot, REG_UTP_TASK_REQ_DOOR_BELL);
>>> + /* Make sure that doorbell is committed immediately */
>>> + wmb();
>>
>> Is this wmb() after ringing tm doorbell is needed?
>
> Well, Mita, in the case of DB register (Request DB and TASK DB), every
> write operation to the DB should be barrier, as if not, out of order
> writing to this register might cause inconsistency in its value, and thus,
> un-handled requests/tasks.

I couldn't fully understand why out of order writing to TASK DB
register causes inconsistency.
In the TASK request completion (ufshcd_tmc_handler), TASK DB register
is read before handling finished requests, so it ensures that all
write operations for TASK DB have been performed.

>>
>>>
>>> spin_unlock_irqrestore(host->host_lock, flags);
>>>
>>> --
>>> 1.8.5.2
>>>
>>> --
>>> QUALCOMM ISRAEL, on behalf of Qualcomm Innovation Center, Inc. is a
>>> member of Code Aurora Forum, hosted by The Linux Foundation
>>> --
>>> To unsubscribe from this list: send the line "unsubscribe linux-scsi" in
>>> the body of a message to majordomo@vger.kernel.org
>>> More majordomo info at http://vger.kernel.org/majordomo-info.html
>>
>
>


\
 
 \ /
  Last update: 2015-10-26 13:41    [W:0.066 / U:1.144 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site