lkml.org 
[lkml]   [2014]   [Sep]   [29]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH v2 1/3] dmaengine: qcom_bam_dma: Generalize BAM register offset calculations
On Mon, Sep 29, 2014 at 10:03:07AM +0530, Archit Taneja wrote:
> The BAM DMA IP comes in different versions. The register offset layout varies
> among these versions. The layouts depend on which generation/family of SoCs they
> belong to.
>
> The current SoCs(like 8084, 8074) have a layout where the Top level registers
> come in the beginning of the address range, followed by pipe and event
> registers. The BAM revision numbers fall above 1.4.0.
>
> The older SoCs (like 8064, 8960) have a layout where the pipe registers come
> first, and the top level come later. These have BAM revision numbers lesser than
> 1.4.0.
>
> It isn't suitable to have macros provide the register offsets with the layouts
> changed. Future BAM revisions may have different register layouts too. The
> register addresses are now calculated by referring a table which contains a base
> offset and multipliers for pipe/evnt/ee registers.
>
> We have a common function bam_addr() which computes addresses for all the
> registers. When computing address of top level/ee registers, we pass 0 to the
> pipe argument in addr() since they don't have any multiple instances.
>
> Some of the unused register definitions are removed. We can add new registers as
> we need them.

Vinod,

These changes replace the patch set I had that implemented support for the
v.1.3.0 register set.


--
sent by an employee of the Qualcomm Innovation Center, Inc.
The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum,
hosted by The Linux Foundation


\
 
 \ /
  Last update: 2014-09-30 00:21    [W:0.062 / U:3.436 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site