lkml.org 
[lkml]   [2014]   [Sep]   [24]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH 16/22] phy: phy-stih407-usb: Add dt documentation for USB picophy found on stih407 SoC family
Date
From: Peter Griffin <peter.griffin@linaro.org>

This patch adds the dt documentation for the usb picophy found on stih407 SoC family
available from STMicroelectronics.

Signed-off-by: Giuseppe Cavallaro <peppe.cavallaro@st.com>
Signed-off-by: Peter Griffin <peter.griffin@linaro.org>
Signed-off-by: Kishon Vijay Abraham I <kishon@ti.com>
---
.../devicetree/bindings/phy/phy-stih407-usb.txt | 30 ++++++++++++++++++++
1 file changed, 30 insertions(+)
create mode 100644 Documentation/devicetree/bindings/phy/phy-stih407-usb.txt

diff --git a/Documentation/devicetree/bindings/phy/phy-stih407-usb.txt b/Documentation/devicetree/bindings/phy/phy-stih407-usb.txt
new file mode 100644
index 0000000..1ef8228
--- /dev/null
+++ b/Documentation/devicetree/bindings/phy/phy-stih407-usb.txt
@@ -0,0 +1,30 @@
+ST STiH407 USB PHY controller
+
+This file documents the dt bindings for the usb picoPHY driver which is the PHY for both USB2 and USB3
+host controllers (when controlling usb2/1.1 devices) available on STiH407 SoC family from STMicroelectronics.
+
+Required properties:
+- compatible : should be "st,stih407-usb2-phy"
+- reg : contain the offset and length of the system configuration registers
+ used as glue logic to control & parameter phy
+- reg-names : the names of the system configuration registers in "reg", should be "param" and "reg"
+- st,syscfg : sysconfig register to manage phy parameter at driver level
+- resets : list of phandle and reset specifier pairs. There should be two entries, one
+ for the whole phy and one for the port
+- reset-names : list of reset signal names. Should be "global" and "port"
+See: Documentation/devicetree/bindings/reset/st,sti-powerdown.txt
+See: Documentation/devicetree/bindings/reset/reset.txt
+
+Example:
+
+usb2_picophy0: usbpicophy@f8 {
+ compatible = "st,stih407-usb2-phy";
+ reg = <0xf8 0x04>, /* syscfg 5062 */
+ <0xf4 0x04>; /* syscfg 5061 */
+ reg-names = "param", "ctrl";
+ #phy-cells = <0>;
+ st,syscfg = <&syscfg_core>;
+ resets = <&softreset STIH407_PICOPHY_SOFTRESET>,
+ <&picophyreset STIH407_PICOPHY0_RESET>;
+ reset-names = "global", "port";
+};
--
1.7.9.5


\
 
 \ /
  Last update: 2014-09-24 16:21    [W:0.255 / U:0.032 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site