lkml.org 
[lkml]   [2014]   [Jul]   [3]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH 6/6] thermal: Add Tegra SOCTHERM thermal management driver


On 01/07/14 21:26, Stephen Warren wrote:
>
> Ah, so there's some manufacturing calibration process that sets some
> fuse value, and the HW uses a combination of that fuse value, and some
> parameters of the manufacturing process as represented by the
> SENSOR_CONFIG2 register, to apply the calibration? I wonder why
> SENSOR_CONFIG2 is a register not a fuse in that case, but anyway...
>
> Perhaps some comments or kerneldoc in the definition of struct
> tegra_tsensor would be useful?

Yes, I'll add some comments.

>
> Why not read THERMCTL_INTR_STATUS inside the IRQ thread. IIRC, if the
> ISR wakes an IRQ thread, the interrupt remains disable until the thread
> has run its course, so there's no issue deferring the register read
> until the thread runs, at which point, the thread can simply loop over
> all the sensors.
>

If that's the case, then that's definitely a better way to do it.


\
 
 \ /
  Last update: 2014-07-04 00:21    [W:0.229 / U:0.084 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site