lkml.org 
[lkml]   [2014]   [Jul]   [25]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH RESEND v2 1/4] pinctrl: Update Qualcomm pm8xxx GPIO parameters definitions
From
Date
On Thu, 2014-07-24 at 17:23 -0700, Stephen Boyd wrote:
> On 07/24/14 08:40, Linus Walleij wrote:
> > On Thu, Jul 24, 2014 at 1:47 AM, Stephen Boyd <sboyd@codeaurora.org> wrote:
> >
> >>> Please add these constants to the table of valid power-source values and use
> >>> something like I did to translate them to register values - it makes the DT
> >>> much more readable.
> >> The DT could be similarly readable if we had a bunch of #defines for the
> >> different VIN settings that resolved to the final register value for
> >> that pmic. Something like PM8921_GPIO1_14_VPH, PM8921_GPIO19_36_VPH,
> >> etc. There would be a lot of them, but then the driver could be really
> >> simple and just jam whatever value is in the DT into the register
> >> without having to bounce through a mapping table in software to figure
> >> out the register value. If we did this for the functions also then I
> >> believe we achieve readability without requiring a bunch of drivers for
> >> each and every single pmic?
> > Not sure but it sounds like you want to make the device tree a jam table,
> > (know about individual register offsets, sequences etc). That has been
> > throrougly NACKed in the past, because DT is not Open Firmware.
> >
> > The exception is pinctrl-single which is restricted to single register
> > per pin use cases and is still a point of contention...
> >
>
> I'm not proposing a jam table. I'm proposing that we make the
> function/source property convenient to the driver by having the actual
> function field value encoded there instead of some string that has to be
> translated through a table in a driver. There's still going to be
> shifting and masking of bits in the driver to put the value in the right
> place in the register, but we avoid needing N number of drivers for each
> pmic just to translate strings into integers (for functions) and
> integers into other integers (for the power source).

This sounds good to me. Drawback is that we will have custom
function parsing code, but I will try and see what that looks like.

Thanks,
Ivan


> From what I can
> tell there isn't any benefit to having the function property be a string
> vs. a #define number besides having a human readable string in pinctrl
> debugfs. Is there some other benefit?
>




\
 
 \ /
  Last update: 2014-07-25 17:41    [W:0.107 / U:0.244 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site