lkml.org 
[lkml]   [2014]   [Jul]   [24]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
SubjectRe: [PATCH RESEND v2 1/4] pinctrl: Update Qualcomm pm8xxx GPIO parameters definitions
From
On Thu, Jul 24, 2014 at 1:47 AM, Stephen Boyd <sboyd@codeaurora.org> wrote:

>> Please add these constants to the table of valid power-source values and use
>> something like I did to translate them to register values - it makes the DT
>> much more readable.
>
> The DT could be similarly readable if we had a bunch of #defines for the
> different VIN settings that resolved to the final register value for
> that pmic. Something like PM8921_GPIO1_14_VPH, PM8921_GPIO19_36_VPH,
> etc. There would be a lot of them, but then the driver could be really
> simple and just jam whatever value is in the DT into the register
> without having to bounce through a mapping table in software to figure
> out the register value. If we did this for the functions also then I
> believe we achieve readability without requiring a bunch of drivers for
> each and every single pmic?

Not sure but it sounds like you want to make the device tree a jam table,
(know about individual register offsets, sequences etc). That has been
throrougly NACKed in the past, because DT is not Open Firmware.

The exception is pinctrl-single which is restricted to single register
per pin use cases and is still a point of contention...

Yours,
Linus Walleij


\
 
 \ /
  Last update: 2014-07-25 06:21    [W:0.086 / U:2.116 seconds]
©2003-2017 Jasper Spaans. hosted at Digital OceanAdvertise on this site